Scooter stalls driving over sliding door tracks; scooter dies

Question edited for clarity. The important stuff is what it is FIRST.
Question moved from Cars and Trucks.

There is often a place in the upper track that has a notch to allow the upper rollers to go up and be lifted off the track. So to remove, you get the door in the right place, lift up and pull the bottom out and off.

Help and videos in the link.

https://www.google.com/search?q=panavista+sliding+mirrored+wardrobe+door+remove+door

..

Are the track clean. They have a pressure switch so it may think that something is in the way and opens to prevent injury to obect or person.

2004 Ford Explorer Engine Stalls/Cuts Out While Driving: 31 ...

www.carcomplaints.com/Ford/Explorer/.../engine/engine_stalls_cuts_out...

... 2013 · 2012 · 2011 · 2010 · 2009 · 2008 · 2007 · 2006 · 2005 · 2003 · 2002 · 2001 · 2000 ... 2004 Ford Explorer engine problems: engine stalls/cuts out while driving ...to overheat and slide out of its socket, causing the engine to shut off. ..... Suddenlyat 30-35mph, my engine just died and i cannot control the steering wheel.

2005 Ford Escape Engine Shutdown While Driving: 24 ...

www.carcomplaints.com/Ford/.../engine/engine_shutdown_while_drivin...

The 2005 Ford Escape has 24 complaints for engine shutdown while driving. ...January 22: Ford Ranger Driver Killed by Takata Airbag in South Carolina news ' 2 days ago; Ford Focus Door Latch ..... I was 80 miles from home when the engine shut off. .... No one could seem to determine the true cause of the problems.

Ford Ranger Stalling/Dying Problems - Edmunds.com

forums.edmunds.com > Ford > Ford Ranger

Nov 2, 2007 - 31 posts - ‎21 authors
Learn more about Ford Ranger at the Edmunds.com Car Forums! ... cut off a couple of times then it started happening more frequent while driving. ..... the other day I was driving down the highway and it just shut off, no warning .... 2000. when it gets overheated the circuit shorts and causes the engine to die. Ford Expedition engine cutting off while driving
31 posts
Oct 24, 2009
Mercury Mountaineer Start Stall Idle Problems
31 posts
Oct 1, 2007
More results from forums.edmunds.com

what about the little roller wheels in the bottom of the patio doors?'

One of your hydro pumps are seized. this is causing the engine to stall when ever the torque is transferred to the pump. There are the small pumps (or final drives) under the engine. One or both need to be replaced

first you go to local book store or dealer or ebay and pick up a chilton or haynes book it will come in handy for the wiring and the hinge torque and allinment specs and tricks

usualy there are 2 ajustment screws at the bottom in the flashing
if you lift the door out of the track and look at the bottom you will see the rollers and likely the ajustment screws is there are no adusters make sure the rollers are free f not spray with penetrating oil and let sit untill free then try again
if sash or frame is tight try spraying it with pledge furnature polish the light grease coat will allow plastic parts to move freely once again

Check your batteries, they might be ready to die. Stalling is a sign your are not getting enough power to the scooter and when you do, it runs until they run low again. Kinda like a cell phone batt, ones it dies and you wait awhile you can get it started but only for a couple of minutes before dying again.

Something similar to that was happening with our Odyssey...the beeping when you are driving whether it's ongoing or intermittent is the "safety alarm" letting you know the door is not closed. The power lock is not engaging. What I do when I get the beeping while driving is hit the Door Close button. It causes the door to attempt to engage again. To fix it...we first cleaned out the space below the side running board (kids were hiding crayons and things in there), then looked for any obstructions along the top and bottom tracks. I sprayed a lubricant along the tracks (I'd suggest the dry lube kind...I used WD40 the 1st time and had streaks of it dripping down after driving), use a lube that has a long straw to spray in small places...and spray up into the track that runs the length of the middle of the car. Manually open and shut it a few times to get the tracks lubed, then try it out.
If you press the open OR close button by remote or in the car and get nothing...no movement/no noises/no beeping...then it could be the electrical circuit itself, the signal itself may be impeded...or the motor shot. Have you tried any of these suggestions before?

fuel pump change required