Philps ftr 9965 match line pixel plus have a problem i am on the tv in remote then display & sound are fine and off the tv remote and start after few seconds then no display in screen and sound is perfect then off the remote and after 25 to 30 mintes then on display and sound every thing is perfect i want to set the color the green color is excse

If you wish to get some details; visit the site linked here. Pull up older posts. Surf the site with patience. http://electronicshelponline.blogspot.com/
Faults & possible causes to LCD & Plasma screen are given with illustrations. You can get an idea about the fault to an extent.

check your lcd lap drive to see if you have power to the lamp drivers

GUEST... thank you very much.. works fine with my voyage ;)

Please check the links below for some tips:

http://www.espares.co.uk/search/remote-controls/p/1090?utm_campaign=06-2011+unlimited+credit+1st&utm_medium=email&utm_source=emails ........ search for models of all types

For codes check on:

http://www.xdiv.com/remotes/

http://www.hifi-remote.com/ofa/codes-tv.shtml#tv

http://www.logitech.com/en-in/440/3898?selectedcrid=440&selectedcid=3898&WT.z_sp=Product&osid=&bit=
For remote codes on Philips:
http://www.usa.philips.com/c/remote-control/12532/cat/#/cp_tab1

?? ??????? ???????? ?? ?? ????? ???? ???????? ??? ????? ?? ??? ??? ?????????

Thats a pixel data problem, there's no data being sent to that row of pixels so they don't change color. This is a pixel address registry (PAR) issue and the PAR circuits need to be serviced its usually due to open or shorted SMT components on the PAR circuits. PAR also sends data, voltage, and control to each pixel, the green line you see are pixels that have voltage but because there's no data sent too them their all green because there's no control. If the pixels have voltage but no data or control they show up as green red, blue, yellow, or whit line vertically down the LCD panel. The vertical-horizontal section of PAR are controlled by 16 to 32 bit micro-controllers which may need replacing. If its under warranty take it back if not have your local repair center fix the tv for you...

Hi there ,

What you can try is to boot in SAFE-Mode, by pressing the F8 key on your keyboard more continiously when turning on your pc, If you are able to view the desktop in safe mode, then you must set your screen resolution lower, but if still no display, then your display adapter might be faulty, check your RAM, remove and re-insert them into the motherboard...try that......Let me know how it went

Regards
Techmor

I have a philips E box w/ pixel plus. my tv died. i paid over $400 for the flat tv receiver FTR 9965. send me an email and i will gladly sell for $100. [email protected] 813-477-4517 i have just placed it on craigslist in Tampa, FL

Rick

can i have code please

You need to fix power supply module (replace electrolitic capacitor on PCB) in your plasma. It's very frequently failure for this device.