HI, I would like to clean Kota...got any suggestions? Thanks, Terri

According to Amazon, the only thing that comes in Monty's box is Monty, 4 C cell batteries and a "discovery sheet". There are several pages about the Kota dinosaurs with a lot of information including Amazon. I'd suggest contacting Hasbro for the "Discovery Sheet" if you can't get the info from the Amazon page http://www.amazon.com/Playskool-Kota-Pals-Monty-T-Rex/dp/product-description/B001WSCU34/ref=dp_proddesc_0?ie=UTF8&n=165793011&s=toys-and-games or this specialized site about the Kota series. The hasbro contact page is here

There is more than the shaft, there is the housing and then everything needs to fit and have correct clearances.....I suggest sell the old one and get a 52 inch new one...

hi,
Visit to the given link and in search box enter your product model no..
http://www.thefind.com/search?query=minn+kota+weedless+propelle
..... OR.....

http://stores.ebay.com/PowerBoats-Unlimited_Trolling-Motor-Accessories_W0QQ_fsubZ16863999QQ_sidZ679023026?_nkw=Minn+Kota+weedless+&submit=Search
Click on product -> see all details -> description..
Hope this has helped you.. Thanks...

hi terry. go through the menu on your camera and find the reset. push it. it will take you back to the factory settings and should solve your problem.

please rate my answer as very helpful. thanks

Hi!
Here is a schematic for your motor:
Endura 30
It sounds like the motor has leaked water into it and wil need to be cleaned up, have the brushes, seal kit and bearings replaced.
Best of luck!
Mike

Hi!
Here is a schematic:
Max 55
There is no LIGHTED directional indicator, but there should be an indicator nonetheless on top.
Best of luck!
Mike

You should only run the motor with a 24v battery or two 12v batters 'jumped' out. To jump the two batteries, connect the positive on one batter to the negative on the other battery and hook the trolling motor battery cables up to positive and negative terminals that are NOT jumped out as you would normally. Don't run this with 12v as you will have serious problems if you do. They do not make a 65lb thrust in 12v - too much pound thrust to run off of 12v.

Hi!
For starters, here is a schematic:
Endura 30
Check to see if there is appropriate voltage getting to the switch (with an ohm meter).
You can (please do this carefully) disconnect the battery positive and negative as well as the motor red and motor black wires and connect the Batt positive to the motor red and the Batt negative to the motor black. If the motor runs, the switch is faulty. If it doesn't then I suspect the motor needs looking at.
Best of luck!
Mike

Raventrans click this link to take you to a website which will you can click on schematics. I suggest adding a 50 amp fuse for your 70 lb thrust unit. scroll to the end of the schematic to find the battery hookup for a 24 volt hookup.

http://www.mikesreelrepair.com/./index.php

Hi, I sent my camera to the dealer...thanks anyway, Sevendata