Canon MF 6530 Paper Jams at fuser ,always the same about 2 inches through the fuser , Same issues from bypass tray is this mechanical problem or a electronic

this>?
Xerox Phaser 6125 printer. told wrong?
get it serviced
and watch them, do this, cleaned all paths and blew out all sensors
cleaning is hard work watch them do it all
how and materials used
call them. now.
or read page on fuser jam here/.
pdf page 95

https://www.manualslib.com/manual/339573/Xerox-Phaser-6125.html?page=95#manual

using Xerox parts or clones, fuser and cartridges./

Does paper jams using every paper drawer? Even multipurpose tray?

1. Up to where paper traveled.. If its reached up to Fuser assembly & curl folds accrued under cartridge.. replace Teflon sleeve or Fuser assembly.
2. If paper traveled up to Fuser out(near 2-3 inch)...Clean/replace/flag Fuser out paper sensor
3. If paper traveled up to registration assembly:Clean registration sensors/flags.
4. Check pickup rollers.

I use to have an HP All-In-One Laser Jet printer that, for reasons unknown to me, wouldn't print after clearing a paper jam until I replaced the ink cartridge.

Clean the pick up roller, try to see where is stuckes. In some cases the roller holders breaks down and roller wont turn.

The problem has been resolved. Thank you.

it would help to have a bit more information on where the paper jams. but ill give this a shot any way. 241 jams clean or replace the pick wheels on the auto compensator. 201 jams no paper present change main motor drive. paper stops 3 inches through the fuser timming issue check the paper size i the paper menu check the fingers on the side of the tray letter is the 2 bottom fingers sticking out. if you have network port print the network page if it is smaller than the page change paper selction pcb located behind the logic pack. if the the line at the bottom of the read out is missing and the box is incomplete the printer is reporting leagal size paper change the paper size pcb. 202 errors check the sensor flags on the fuser. there are 2 sensors on the fuser the one on the left is the narrow media sensor the one on the right is the exit sensor. check to make sure the sensor flag is not broken. check them for fluid movement if you cant hear them snap back replace the sensors hope this helps you out

I would reset the Photo conductor unit. It will have a Green drum in it. I would make sure it is set in the machine all the way, and that the drum door opens completly. BLANK copies are and indication the paper has NOT touched the drum to recieve an image.

We have a photocopy canon MF 6530 and on the screen appeared information Platen glass dirty , clean platen glass.
I have clean glass there we put paper for copy , but it seems that is not this problem, Photocopy stoped copy or print it use just paper.
Could you please let me know what do I need to clean.

Yours sincerely
Gintas Vilpisauskas

Did not specify where it is jamming?

is the paper size correct?
is the paper under the metal tabs in the tray?
is it jamming in the fuser?
is the fuser OK, if constant jamming in fuser then replace.