Have an older Canon copier NP 1020. Error code E0 flashes when turned on. Do not have an Owner's Manual or Service Manual. Have been told it might be a "fuser code". Something for the heating element. Need to know what this code is. Where is it located and how to repair? Would a service manual for a 1010 work with a 1020?
Been searching the net in feverously for a service manual in vain. Thanks so much for any help.
Regards, Mark
[email protected]
Pretty much the same, the codes are good for several models not just one.
you need to find the other numbers to know exactly which code it is, press the start or stop key to see it display the other #'s.
fuser is on the left side if you replace the parts might as well replace the claws and oil roller.
"E000"
Heater lamp, Thermistor, DC controller
"E001"
Heater lamp, DC power supply / AC Driver circuit board, Thermistor, DC controller.
"E010"
Main motor clock sensor, DC controller PCB, Main motor, DC power supply / AC Driver circuit board
1,722 views
Usually answered in minutes!
×