At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
Re: Funtional code SC101-00 appears on Lanier 5245 copier...
Hello!
There you are. You asked the question but you already know the answer.
The exposure lamp are burned so... this error code appears in the display.
You need to change the exposure lamp
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
make sure the top lamp lights when you press the print key if the lamp does not come on check the lamp harnes, the fuse, the lamp and the exposure board replace if either is faulty
exposure lamp open circuit replace or lamp regulator faulty also check thermo fuse
1st thing to check change auto exposure to manual this will tell you if regulator is faulty or not
sc541 means no warm up, press the clear modees the punch in107 then press and hold down the clear stop key untilk it goes into sevice mode then shut main power
Your problem in the exposure lamp unit.Check the expo lamp,expo thermofuse continuity,and perform the Auto Image Density Sensor control proces after the clean the mirrors and the glass.
No, you can't reset. You'll need a tech.
Here's what the manual says:
Symptom (SC101)
- Exposure lamp error
- The standard white level was not
detected properly when scanning the
white plate.
Possible Cause:
? Exposure lamp defective
? Lamp stabilizer defective
? Exposure lamp connector defective
? Standard white plate dirty
? Scanner mirror or scanner lens out of
position or dirty
? SBU defective
SC101 can be caused by a dirty WHITE LEADING EDGE STRIP. This is located under the left side plastic strip that holds down the exposure glass on the left side. Remove the screws, and flip over the glass holder. Clean the white strip with glass cleaner, and reassemble. If SC101 reappears, the scanner drive pulley screws are loose or broken off. A service technician is required for this repair.
×