Power sw reset sw power led hdd led where is located in the mother board intel e 210882?

http://www.cintelcorp.net/msi-ms7528-manual

Hello Sir, hi, the wires on your casing are usually labeled, like in the picture below:

the power led green wire goes to the power led + and the white goes to the - . Now the HDD + goes to the HDD + the red wire, power switch can be interchange, same as the reset switch.

> power led,

Runs to the LED (Light Emitting Diode) labelled "power" on the front of your computer-case

> H.D.D led,

Runs to the front-panel LED that lights-up whenever the Hard Disk Drive is being used.

> reset sw,

Runs to the "reset" button on the front panel.

> speaker

Runs to the internal speaker

> s/b sw

Very briefly touch a metal-tip screwdriver between these 2 pins.
If the computer powers-on, you've found the "power" connector.

firstly u find 9pin jack on motherboard its near about pci slot and their is print power switch,power led and reset switch. some wires are  comnig from your cabinet their is print po sw,reset,hdd,pwd led

Here is the link to read and find out where you connect power led & etc.:
A tip where you can recognize also in your motherboard.

Rhis is where you will hook in the connections from your case. These are mostly the different lights on your case, such as power on, hard drive activity etc.

Open this browser:

www.yboyandrei.com/865GV

Good luck!

If i am helpful to you, please rate me.
Thank you.

Yboyandrei

refer ur motherboard guide

it is written in the motherboard..
re-reset botton
pw- power botton
hdd led- hard disk led
pw LED- power led

the code is pin 1....

Fiend your solution direct from intel. Here is your solution........



http://www.intel.com/motherboard/prob676ijt65/solution
97

To download you're manual for the D815EEA2, please click the link below.
ftp://download.intel.com/support/motherboards/desktop/D815EEA2/EA2FV_English.pdf
You need to go to page 85.
Starting at Pin 1 (Hard drive LED) is positive + & pin 3 is ground -. Next, Power LED, Pin 2 is + & pin 4 is ground - .
Letter C, is for the reset switch, Pin 5 is + & pin 7 is - .
Power on/off switch, pin 6 is + & pin 8 is - .
The letter I is used for the internal speaker. The positive pin number 16 & ground pin number 10, letter G

Good Luck!
Have more questions? Please feel free to ask.
Mike