Not cooling at all. We moved from AZ to SC it was working fine. Compresser and fan are running, cleaned it and still nothing it's been plugged in for 40+ hours and seems hotter now? Is there a reset time for the computer board?

Dependingmon the length of run time will determine the problem. If the compresser cycles on and off within a couple of minutes then you are looking at a bad compresser. If it runs for 5-10 minutes then cycles off, you have a plugged off condenser or dead condenser fan motor, in which case do not run the fridge until the motor is replaced and cleaned. If the compresser runs for hour or so with no cooling effect then you may have a plugged off cap tube which means a repair man will need to take care of that. If the compresser cycles every 10-30min with a little cooling in the freezer then you are looking at a bad thermostat. Hope this helps

If the fridge is not cooling down at all I would listen for the humm of the compresser, if you hear it then you may have bad valves in the compresser or other refrigeration problems, I would then also check to make sure all fan motore are running. If the compresser is not running you may need to look at the power source or it could be just a faulty thermostat. I would check the thermostat to make sure you are getting power through it. If it is not getting through the t-stat then nothing will turn on Hope this helps

Could be a couple problems. The thermostat may not be making the contacts close to tell the compresser to turn on all the time. The compresser could be overloading which would be caused by overheating (clean the condenser). The freezer and frige evaperators may be becoming frozen up due to a bad defrost timer. When the freezer warms up check to see if the compresser is running, if it is not put your hand un it, if it is hot then it's overloading and should be replaced. If it is running and isn't really hot check to make sure all of the fans are running, should be one condenser fan and one on each evaperator. And look for ice build up inside the freezer and fridge. If all the fans are running and coils are clear and compresser is running next st is a plugged cap tube which is the metering device to the evaperators. The mechanic can trim them down six inches and fill the system and they should work great again. Hope this helps

Could be a few problems. What I would do is check to see if the compresser is running by pulling out the fridge and pulling the back panel off and putting your hand on the compresser. If it Is vibrating then it is running. If it is not vibrating but very hot then the compresser is dead and needs to be replaced. If the compresser Is cool and not running I would say the thermostat inside the fridge is dead(bad contacts in the control). If the compresser is running but no cooling, the cap tube which is the metering device for the refrigerant into the freezer evaperator could be plugged off. Or if none of the lines off of the compresser are hot or cold then the valves inside the compresser are gone and compresser needs to be replaced hope this helps

Sounds like it's overheating. Check to make sure your graphics card cooling fan and CPU cooling fan are working. If they are add some case fans. Get a can of compressed air and clean out all the vents and fans. You can also use a vacuum with a hose attachment to clean it.

Whether its a central air unit or a wall unit, make sure the condensor is clean and air can flow thru it
make sure the condensor fan is running, the condensor fan keeps the compressor from over heating
if the condensor fan stops running the compressor will over heat and trip the circuit breaker. good luck!

Hi,

Check out these tips...they can help you figure out what is going wrong withyour refrigerator and why it is not cooling

Refrigerator not Cooling or Fridge not Cooling

How to Defrost Refrigerator Defrost Timer Problem

Water Running in refrigerator from Freezer

Refrigerator or Freezer not Cooling or Getting Cold
heatman101

'';;'

check the fan, if its dusty clean it then run the player. If it works, your in luck. If the fans are moving and f61 still shows up, the D-amp IC is shortened ( inside you will see IC 5000/IC5200 / IC 5300, these needs to be replaced) its the one by the big cooling fins (behind the rear fan)

Cooling fan is probably dirty or not running. Check the fan by removing it with the two screws on the back and make certain that it's plugged in and the short, black wire (that appears to go to nothing) is "securing" the plug to the board.

Had the same problem. Found that the code refers to the cooling fan. Could be that the fan is dusty or not running when the system starts up. I removed the fan with the two screws and reseated the plug. Make certain that the short, black wire (that seems to go to nothing) is securing the plug to the board.