The hp colour laserjet cm6040mfp is displaying error 50.0 fuser error. pls i need ur assistance on it.

Hi,

you might need to update the fuser assembly. Please ensure that there are no other issues (ie paper jam or low toner level) before restarting your printer. Otherwise, please ensure that your printer isn't overheating. If so, turn it off for 30 minutes before using again.

Thank you.

Steps To Fix HP Printer is Displaying A 50.4 Error Message

1. First thing you have to do is to cancel all the pending printing jobs in the queue.
2. Now switch-off your printer and leave it for few seconds to cool it down.
3. After cooling down the printer completely, the fuser failure error appears on the display screen.

https://www.hpprintersupportpro.com/blog/hp-printer-is-displaying-a-50-4-error-message/


https://www.laserprinterservices.com/hperrorcodes.html
HP Printer Error Codes HP Laser Printer Error Code 13.4 paper jam 50.1 Bad Low Voltage Power Supply 13.5 Paper jam in the fuser 50.2 Fuser Error 13.6 Paper jam in the fuser 50.5 Fuser Error 13.20 jam in the paper feed drive 50.9 Fuser Error

Pressure release mechanism error in fuser, you already replaced the fuser.. then check below connectors.. Remove rear door...>Check connectors:J1720,J1965,J1964 &dc controller PCA connector J105 & J121..shown in fig>check fuser driving gear,>Fuser driving motor as shown in fig>Fuser sensor flag & pressure release sensor> perform sensor test... administration..scroll to trouble shoot..sensor test..perform all sensors as shown in display.. check sensot test passed or not...

You will need to order a fuser and replace it or call a service tech who can. The problem is that the electronics on the fuser have actually burned out, so that is why the whole fuser needs to be replaced.

Yes they will

50.2 Fuser Error Turn off then on Description 50.2 Slow fuser error. The device has experienced an internal hardware error. Action

1. Turn off the device, wait at least 25 minutes, and then turn on the device.
2. If a surge protector is being used, remove it. Plug the device directly into the wall socket. Use the power switch to turn on the device.

if no result,
Fix this with a new FUSER Assembly for HP Colour Laserjet 2600/n (200/240v) Part Number: RM1-1821-240CN or Fusing Assembly – RM1-1820(110/120v )

Hi,

A 50 Service error is a fuser error. Turn the printer off for 5 to 10 minutes, then turn it back on. If the error is still there, I think your going to need to make a service call you can try reseating the fuser, but be sure to let the fuser cool completely before touching it.
Good Luck the HP Laserjet 4p is a great printer.

HP error message 50.X is usually a fuser error. replace fuser

If the display panel reads 50 FUSER ERROR, CYCLE POWER, turn the printer off for 15 minutes. This allows the capacitor that is responsible for signaling this error to discharge. If you don't wait 15 minutes you will continue to get this error even if you have replaced the fuser. If it continues to show the error, then you need to replace the fuser. It is easy to replace.
The fuser maintenance kit is about $119. on the web.
If I could be of further assistance, let me know. If this helps or solves the issue, please rate it.
Thanks, Joe


I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_8b8c2cd6ce148309

For any fuser error, the first thing that should be done is replacing the fuser. If the error still shows up after wards, it could be the LVPS (Low voltage power supply) or a board.