I have an excalibur alarm on my car. i replaced battery and now it will not start, im thinking its the alarm. how can i reset the alarm.

notify manufacturer of alarm for assistance

you can try out some guide from reliable-store
they also provide live chat feature for instant help and it's very useful
using that I fixed my
own excavator 5-6 times without any other help
plus free so whats harm in not getting

im working on a 97 ford f-150 with a 4.2 l itre engine ive replaced the coil pack on it.has a a spark to plugs,but wont start,tied to retreive codes off computer could not get none.not avaiable it said .Do you think the computer is out,let me know.

buy new

a lot of times car alarms go off when they since a voltage drop in the vehicles battery test or replace cars battery

http://www.caralarm.com/manuals/Excalibur/AL-1000-SH.pdf

Check out page 15. There has to be a reset button somewhere. Have you found the unit and traced all the wires to there source?

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

look up how to reset python alarm (model #) for 2004 jeep grand cherkee. there a few steps to it,

The Touch remote can be used with any Echo compatible systems. These systems can be identified by their model numbers. Systems ending in E, EDP and EDPB are Echo compatible.

i have a Excalibur AL1830EDPb Remote Start Alarm 2 Way. I only have a range of about 60 ft from from the car, should this not be about 3000 ft

locate the brain under the drivers side under-dash area. this may require you to undo a couple of bolts. you will need a 7MM and a 10MM depending on the year of the truck. from there you can unplug the the 6 pin main ignition harness from the brain. it may just be that the battery is no good. a trip to one of the major chain auto part stores can have them check your battery for free. Good luck.