How do i take agitator out of speed queen awn412 washer

Speed Queen AWN542 using the delicate cycle. Provides a brief
wash, 3 minute pause, quick agitation, then slow speed spin drain.

https://www.youtube.com/watch?v=VRyowST7tYo

https://www.pwslaundry.com/c-295313-commercial-speed-queen-awn412sp111tw01-top-load-washer-parts-for-repair-service.html?msclkid=e3bfa3c0ea10105c5fb3fe38f5e42190&utm_source=bing&utm_medium=cpc&utm_campaign=CPCS_DSA&utm_term=pwslaundry&utm_content=All%20Website

I hope that you ordered the correct part, Also there is an idler pulley that maintains the belt tension and that needs to be checked for proper tension.

The motor is stuck and not turning. Do not power on and locate source of problem. Could be bad motor bearings or something in the power chain causing the problem

This was posted earlier.
Please check for info. How to empty the washing machine lint filter

tub will not spin, smells like it is burning

Hello there and thank you for choosing fixya
These knobs are normally the pull off type so all you have to do is get a small flat tip screw driver behind the knob and gently pry it out to get it started then it should slide off
However if you are needing to replace the entire part then the top back section of the machine may need to come off it may even have some screws behind the white side plates that allow to be removed and the top part folds up and back allowing you to axcess the part ok this part is usually held on by 2 or 3 screws

Possible bad water level switch or bad timer.

can i see solution that ziobob got on nov.08 2008