Select "F1" to continue with

Keep trying until the keyboard is ID'ed. Unplug, remove battery, plug in, reboot. Is there a reset button?

Replace the HDD whose led is blinking in AMBER ( orange ) colour.

This is a SMART hard disk monitor Warning. You should probably make a backup on an external drive just in case the drive decides to fail completely.

I’m happy to help further over the phone at https://www.6ya.com/expert/jeremy_69f3cc28d95bf514

click F2 and then change the settings as yo like

I think you should press F2 to go to the setup page.

There, you should change the order of your boot device.

set the first boot device to hard disk

set the second boot device to cd rom

and the third to floppy.

follow the instructions and click save and continue

Please let me know what is the make and the model of the pc that you are using.. Also, go to the bios, under boot menu, make sure that you have hard drive as the first boot option.. For further queries please get in touch..

sounds like your floppy drive is failing, you could get it replaced or simply turn it off via the BIOS.
to turn it off simply hit the F2 key. On the first screen usually it will list your Hard Drives, CD ROMs', and the Floppy. scroll down to the floppy and hit enter ot the corresponding key form the bios's legend at the bottom or right hand side of the screen untill you see disable.
Next you can navigate to Save & exit or hit F10 to do the same. G/L.

Press F2 to enter the Bios, on the first screen navigate to the floppy A: drive select disable and the error should go away.

From the sounds of it your Floppy drive is damaged or just bad. you can take it for repair or purchase a new one fairly cheap and replace it yourself. But just disabling it should do the trick since floppy's are pretty much obsolete.

the recovery Disk wont help you unless its an error you get in windows itself btw.. (unless its a OS start problem which this doesn't seem to be)

after pressing f2.....bios setup was opened.....go to drivers.....and than open diskette driver.....select off .....your problam is solve 1000%

Hi Nick ,

As of now you can Select "F2" to accept data loss and re-enable logical drive. This Load OS Normally .
It seems that one of the HDD in the RAID 5 has failed , Did you notice any LED indications like red or amber on the HDDs ?? if so get that hdd replaced . Make sure the Failed HDD is replaced .
You can run the Array Diagnostic Utility from HP System tools to check the Failed Drives and also frimware version of the controller . If the frimware is not latest Update it from HP website. DL380 G4 should have Smart Array 6i controller .

Hope This was Helpful
cheers :)