Unsupported card Why is a proper memory card (SD) showing up as an unsupported card?Three cards have been tried in this camera and all say unsupported card.

reformat it with fat32 file system.

Make sure you're using an SD card, 2GB or smaller. The 435 will not work with higher-capacity SDHC cards.

Try formatting the SD memory card using the camera's Menu setting.

Try formatting the card and be sure the locking switch is in the off position.

The M415 works with SD cards. Your 4GB card is actually an SDHC card and won't work with the camera. You need to use SD cards, 2GB and smaller.

Here is a diagram to show the correct position of the switch.

Diagram


Good big picture and it doesn't matter that it has Canon written on the SD card in the picture the SD card is interchangeable between the two makes.

Now one other thing that may also be the problem is that the SD card needs to be formatted to the camera. Formatting should be done on new memory cards and after you have downloaded pictures to the computer. That's format not delete, delete leaves a mess on the card Formatting cleans the card and provides proper communications between the camera and the memory card

Once you use a computer to write to a memory card, it no longer works properly in a camera because of the different operating system. The only way for the card to work again is to format it in the camera. This erases and optimizes it for the camera.

A bit more information might be helpful. Is your problem that you cannot view the pictures on your SD memory card while the card is installed in your camera? If this is the case you might make sure the card is properly installed. Sometimes if the card is not fully engaged in the memory slot the camera will not register it. Try removing the card and reinstalling it.

Try taking the SD card out then plug the camera into the p.c then format the internal memory.

check the internal cable which contact with the memory card package, only easy push on it