I need User Manual for my microwave

The filter might need to be replaced. For the manual I would try searching on the companies official website to see if they have a manual for your microwave.

Check your user manual. It should describe how to reset this light. These types of service filter indicators are activated after a set amount of time determined by the manufacturer has elapsed. The microwave has not actually detected a dirty filter, it's just a reminder that its time to clean the filter.

see this causes and fix it. God bless you
Touchpad and Control Panel If the microwave buttons don't work the touchpad and control panel assembly are probably defective.

Touchpad If the microwave buttons don't work the touchpad might be at fault. Generally speaking, if the display is working and some of the buttons respond correctly but some don't, the problem is with the touchpad.

User Control and Display Board If the microwave buttons don't work the main control board is most likely defective and will need to be replaced.

Main Control Board If the microwave buttons don't work the main control board is most likely defective and will need to be replaced.

need user manual ( free) for emerson MWG911SL micro wave.. Cant seem to get anywhere tryin to get it.... ThNKS Z

If your unit is venting to the outside, you would be using one or two grease filters, which can be cleaned, usually with warm soapy water.

If your unit is set to recirculate, then you should be using a charcoal filter, which cannot be cleaned, and must be replaced.

Details and instructions are to be found in your owner's manual.

If for some reason you don't have yours, you can download GE owner's manuals and installation instructions here.

You can find helpful exploded view diagrams and order parts (including filters) by entering your full model number here.

We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.

This is billed as the Use & Care Manual for the Frigidaire FMV156DC Microwave Oven:

ftp://ftp.electrolux-na.com/ProdInfo_PDF/Springfield/316495004en.pdf

Not sure it is the correct one but you will find instruction for cleaning the exhaust filters on page 19.

Below is the Use & Care Manual for a model direct from the Frigidaire site:

http://manuals.frigidaire.com/prodinfo_pdf/Springfield/316495057en.pdf

This is more helpful as on page 20 it includes illustrated instructions for removing the charcoal filter to change the oven light. Disconnect from power, remove the ventilation grate at the top to access the charcoal filter, slide back and lift to remove. With the grate removed carry out any required cleaning.

I have included a link to take you to GE and your user manual which can be viewed or printed.
To remove the grease filter:
To remove, slide it to the
side using the tab. Pull it
down and out.
To clean the grease filter,
soak it and then swish it
around in hot water and
detergent. Don’t use
ammonia or ammonia
products because it will
darken the metal. Light
brushing can be used to
remove embedded dirt.
Rinse, shake and let it dry
before replacing.
To replace, slide the filter
in the frame slot on the
left side of the opening.
Pull up and to the right
to lock into place.
To remove the charcoal
filter, disconnect power at
the main fuse or circuit
breaker panel or pull
the plug.
To change the charcoal filter:
Remove the top grille by
removing the 2 screws that
hold it in place. Slide the
filter towards the front of
the oven and remove it.
http://products.geappliances.com/MarketingObjectRetrieval/Dispatcher?RequestType=PDF&Name=49-40475.pdf

that model sahould be betewwn 900 and 1000
depending on the age they changed it about 3 mosinto produvction

aif you bought it after 98 its 1000 watts

hope this helps

You would be better off to replace the filter. Purchase two and use the first one to capture the remaining smoke residue. Then install the other clean one to keep microwave free of smell. Check the web site www.partselect.com for the replacement filter. If you found any of these suggestions helpful, please rate my solution. D. Lange

External vent systems have the charcoal filter removed, generally at the time of installation, as it is not needed for this application.
The charcoal filter removes odors from internal recycled airflow.
There should be an aluminum grease filter that you can remove to clean in a warm soapy solution, let dry, and reinstall.