You need to perform static and dynamic convergence adjustments in your hitachi tv by going into service mode. It is very technical adjustments and if you now how to perform, then go ahead.
Here is procedure how to go into service mode...
1. TV turned off
2. Press 'Power' and 'Input' buttons on the TV for more than 3 seconds..
Now you are in service mode.
The letter P indicates picture and A indicates audio.
4. Use the 'Menu up or down' on the remote to select the item.
5. Write down the old value of the item before changing.
6. Use the 'Menu left or right' to change the data.
You need to go into your set up menu and select convergance. adjust it and this should help. if it doesn't hen it is a faulty convergance ic module and you will have to contact a local repair service and either replace them yourself(only if you have electronics experienc) or have them replaced for you.. please rate this.......thanks
you indicated that you have an auto focus feature. it is obvious that your focus apeture is not doing what it's suppose to even though the the tv is telling you it is. with the auto focus(magic focus) igt works in conjunction with the convergance. this is a motherboard fault and chances are you need to have someone with the experience(your buddy forinstance check the mother board out.) without being hands on it would be hard for me to pinpoint the exact nature of the problem. please changre the rating to helpful. i'm in the ball park as far as giving you options that qualify... thanks
×
Its the problem of STK ics in the convergence board just get it replaced.the tv will work properly for sure.
it will not be too costly.do not try to do it your self with out technical knowledge.it will be fine.nothing to worry.the tv is perfect just change the STK ics.
pls do rate the solution
thanks.
regards.
fixya expert team
66 views
Usually answered in minutes!
I finally received the correct STKs. My mistake, not the vendor. I had them installed by a guy at work who is an expert in this field. I re-installed the board and powered the television. I now have three distinct pictures colored red, blue and green with some white mixed in. This is a Hitachi TV with magic focus. When the magic focus button is depressed it indicates it is performing the function but when it completes the picture quality does not change. I have tried the manual method but the picture quality is no better after completion. Overall, the picture quality is poorer now than it was before the STK-392s replacement.
I have tried both auto and manual convergence as already indicated. The STK-392 110 and STK-392 150 have been replaced. What other ICs need replaced?
×