I bought the COMPONENT AV CABLE and i Tried to connect my IPAD2 to a SAMSUNG LED TV but it says "no signal" what can I do?

Sounds like a main board issue.

Remove the memory card from the wii , try again and it will work !

most likelly is the tv that does not support the ipad. try connecting it to a different tv with higher resolution.

find a scart lead with same connectors

You usually hear "weak or no signal" when the tv's input is set to air. Check to see if changing the input might help. Or if you are using an antenna to get your tv, then maybe your antenna is not powerful enough. The new digital signal is weaker than the analog, so antennas that once worked might not work as well now. Hope this helps!

This kind of tv u must have cable or satalite tvs pay broadcasting signal cable,so u have a box .Tv have HDMI ports or RCA AV component cable input?The incomming broadcating tv signal go to the cable or satalite boxes.Than u use a HDMI cable or RCA AV component cable go through those boxes than to ur tv HDMI input ports or RCA AV component cable input holes.

the easiest way to get signal to your HT-Z320 is to run the audio cables from your cable or sat box to the input on your theater system...for the dvd either run HDMI to the LED TV or component (whatever it supports) the Wii system can be plugged into any AV -IN on the LED tv (if you want to use the Wii on the theater system you will need to extend your RED AND WHITE audio signal cables to the input on your theater system.

Hope this helps.

ok samsung is partially right you might have paid for bad cables
but on the other hand you will get a better picture with the component
but all you have to do to have those cables work is plug the colors in the back of the tv so they match and then select the port that it is plugged into make sure the console is on

on some of the older ps2 you did have to go into the options menu to change your display options but if thats the case its self explainitory
hope this helpd

Hello

by befault your dvd recorder is transmiting signals via component video, so what you need to do is this connect both cable HDMI and Component or just a video cable then go into setup and then select video out via HDMI your video will go off on the screen and then with TV remote slect input source HDMI on TV and it should work fine.

Thankyou

Is your tv connected to your cable box through HDMI, AV, or component?
_____________________________

If its through HDMI then your cable carrier needs to load updated frimware in your box to communicate properly with your 2005 tv. The firmware loaded in your cable box needs to be "reverse compatible" for first generation HDMI from your 2005 tv. If your using AV or component hook-up and there's no sound then re-check all of your audio settings within the tv's menu. Also recheck the cable-wire your using and proper input/output ports.



ON your dvd player, is your tv connected through component, AV(rca) or HDMI?

If its through "component" then you need an extra audio cable to and from the DVD and tv.