Sandisk Standard Troubleshooting steps

See page 16 troubleshooting of user manual

<363731303030373834355FD3A2CEC4D3C3BBA7CAD6B2E14244573134362E2E2E6D6469> (winnings.com.au)

Its probably ruined the internals of the pump. You will need it rebuilt or replace it. The water is what cools and lubricates the pump. Hope this helps. Chris

Could be an electrical part that only fails after getting really hot. Coils and ignition modules are known for this. Unfortunately, these parts cannot be tested for this heat-soak type problems, other than to see if spark quality at the plugs has degraded when failing. One other thought. A bad gas cap which is not allowing air to flow in as gas is used can cause this and that is a cheap part to replace just for grins.

sandisk recommends 3+ hours for the initial charge and then about 1.5 - 2 hours for after the battery is drained. More information is needed to diagnose this problem. but here is some info. After 45 minutes on the phone with sandisk to get them to send a new battery, they ran me through these troubleshooting steps, hope they help. do one at a time and see if you get a result -Reset device take out battery hold power button for 30 count put battery back in turn device on. -Upgrade firmware Go to website, download firmware update This was the URL at the time of writing this http://sandisk.com/Retail/Default.aspx?CatID=1376 or try http://sandisk.com/Retail/DriverDownloads.aspx Install according to instructions. let the device reboot. -Format memory. turn hold switch on, orange should be visible hold pause/play button and press power. click forward button when the screen comes up. let this run. after reboot flip the hold switch off. then they put me on hold for 10 minutes...

if it isn't the 'hold' switch then there is something wrong internally. if you wanna try... sandisk ran me through these troubleshooting steps, hope they help. do one at a time and see if you get a result -Reset device take out battery hold power button for 30 count put battery back in turn device on. -Upgrade firmware Go to website, download firmware update This was the URL at the time of writing this http://sandisk.com/Retail/Default.aspx?CatID=1376 or try http://sandisk.com/Retail/DriverDownloads.aspx Install according to instructions. let the device reboot. -Format memory. turn hold switch on, orange should be visible hold pause/play button and press power. click forward button when the screen comes up. let this run. after reboot flip the hold switch off.