How to reset it out of demo mode

If your Kenmore Elite refrigerator model 106.5177 is not cooling properly and you suspect it might be in demo mode, you can follow these steps to try to disable demo mode and troubleshoot the cooling issue:

1. Check for Demo Mode:
   • Look for any display indicators or icons on the refrigerator's control panel that indicate it is in demo mode. Refer to the user manual for your specific model to identify these indicators.
2. Disable Demo Mode:
   • If you identify that the refrigerator is in demo mode, you will need to disable it. The exact procedure may vary depending on the specific model and control panel. However, a common method is to press and hold a combination of buttons on the control panel simultaneously for a few seconds until the demo mode is turned off. Refer to the user manual for your model to find the correct button combination.
3. Power Cycle the Refrigerator:
   • After disabling demo mode, unplug the refrigerator from the power outlet and wait for a few minutes. Then, plug it back in. This power cycle may help reset any settings and restore normal operation.
4. Temperature Settings:
   • Make sure the temperature settings for both the refrigerator and freezer compartments are set to the desired levels. Allow some time (usually a few hours) for the refrigerator to reach the proper temperature after adjusting the settings.
5. Check Condenser Coils:
   • Ensure that the condenser coils located at the back or underneath the refrigerator are clean and not obstructed by dust or debris. Dirty coils can hinder the cooling efficiency.
6. Check Door Seals:
   • Verify that the door seals are intact and sealing properly. Improperly sealed doors can lead to loss of cooling.
7. Check for Airflow Obstructions:
   • Make sure that there are no obstructions blocking the airflow to and from the refrigerator, both inside and outside.
8. Allow Time for Cooling:
   • Refrigerators typically take several hours to cool down and reach the desired temperature after being powered on or after any adjustments.
9. Professional Assistance:
   • If the refrigerator still does not cool properly after attempting these troubleshooting steps, it's recommended to contact Kenmore customer support or a professional appliance technician for further diagnosis and repair.

Remember that electrical appliances can be complex, and improper troubleshooting or repairs can lead to safety hazards or further damage. If you're unsure or uncomfortable with any step, it's best to seek professional assistance.

Press the "Freezer" and "Refrigerator" buttons on the control panel at the same time and hold them for 5 seconds.

The control panel will beep, and the temperature settings will be displayed. Keep holding the buttons until the control panel beeps again and the display goes blank.

After the display goes blank, release the buttons. Demo mode should now be turned off.

If the display still shows the word "demo" after following the above steps, try unplugging the refrigerator from the power outlet for a few minutes, then plug it back in and try the steps again.

If these steps do not work or you need further assistance, refer to your refrigerator's user manual or contact LG customer support for additional guidance.

French Door: Why Does The Control Panel Display "OF OF" Instead Of The Temperature? If the control panel displays "OF OF" instead of the temperature, the refrigerator is in "Cooling Off" mode. In Cooling Off mode, the refrigerator appears to be running normally, but the compressor is off so the unit does not cool. Cooling Off mode is used by retailers to save energy when the refrigerator is on the showroom floor.
Note: Cooling Off mode is also called Demo mode or Exhibition mode.

Disable Cooling Off mode by performing the following:

• Left Door: Simultaneously press and hold the top two buttons on the left side of the display panel until you hear a distinctively different chime sound when the display changes. This will either be a combination of "Energy Saver" and "Freezer", or "Energy Saver" and "Power Freeze/Freezer."

Source:
Why Does The Control Panel Display OF OF Instead Of The Temperature...

It still sounds like the child lock is on since that prevents accidental setting changes on the refrigerator's control panel.The following will NOT work if the child lock function is activated: Freezer Temp Button Fridge Temp Button Power Freeze Button Power Cool Button Ice Type Button Water Button Ice maker Water OR it may be in Cooling Off/Demo Mode. Cooling Off/Demo Mode is a feature used by retailers to display the refrigerator without running the compressor. If your unit is not cooling, and the bars are constantly scrolling up and down the temperature, check your manual for reset advice

To disable the Demo mode, perform the following:

1. Turn GA_googleFillSlot("TL-IMU-Article"); on the TV.
2. Simultaneously hold down the Vol+ and Vol- buttons on the front of the TV. Do not use the remote control.
3. Hold for about 6 seconds
4. Certain model TVs may turn off, others will not. But in either case, the Demo mode should be disabled.