Top 20 Learning Curve Toys Thomas the Tank Engine Track Rider Questions & Answers

I would check the battery voltage with a multimeter if possible. Battery should read at least 6 volts. Most likely the battery is too old to take a charge if it’s been sitting unused since 2006. I’d replace the battery first and then go from there.

just pull of the black coal top and it uses 1 c battery

4 hours

From Peg Perego's website:

What do I do if I have a problem with my product that I can't solve myself?
You can call our customer service department at 1-800-671-1701. Customer service hours are Monday - Friday 8am - 4:30pm Eastern time
(http://us.pegperego.com/toys-site/support/TPSEC002/)

Good luck!

re: istbruno
my daughter told me, to squeeze the sides of the train and pull up and there is where the battery goes.
i had the same problem.
hope this helps

yes

well youlle realy need to buy the batteries that could fit and move into the toy you bought. also if the battery you used dindt work. maybe you should try a medium sized battery.

Hey. I was looking for the same thing and found this answer on yahoo answers:
"loosen the phillips-head screw on the underside front center of the jet engine train (you might not have noticed it - it is behind the coupling magnet assembly, which you can move to the side and also has an opening to access the screw) - once the screw is loosened, you can lift up the 'jet engine' from the base to access the battery enclosure"
http://answers.yahoo.com/question/index?qid=20071225073953AAHYJKb

The batteries are low, when the music plays on a toy and the motors stop it usually means low batteries,

Does it have a coal car?
If so squeeze the sides of the coal car and the top pops off.
If it's the blue one with plastic tracks then you have to squeeze the 2 center wheels. The rest,I believe,have screws that make it easier to locate a possible battery compartment.
Hope this helps.
If not I'll call my son...he owned them all. lol

Try searchig E-Bay I normally manage to find any type of battery I have needed. If not research it on GOOGLE you will be able to find lots of suppliers for batteries. I hope this helps.

Hi

Have you tried keep pressing the right hand button down. When you press the button down and hold the press, then the sounds are finished, the trains starts driving. When you release the button the train stops at once.

Take the wheel base of the train in one hand. Point the' face straight up. Place your other hand on the top with you index finger on Thomas' face. Push down towards the ground with the hand on the top, and then pull apart. There is a little tab on the back that you need to get over. Some times the first time is the hardest.

In that case it needs repairing. It sounds like the button is inoperative. You could try electrical contact cleaner. Or return for repair. Or as Larry says, buy a used laptop :>) https://www.google.com/search?q=leap+pad+plus+writing+repairs ..

Hi Joanmsynonds,

There has to be some socket for changing your toy, if in case it has in-built battery.

It may take power while running in the track from the track itself.. Check for how it is designed.

If there exists an in-built battery for your device, then obviously it should be rechargeable only. In case of doubt, visit your nearest toy shop and ind similar model as yours, and study it.

I hope this is useful to you
Thanks

Question edited for clarity and spelling of the maker, 'Spaulding'.

Manuals Page

Spalding.com https://www.spalding.com > customer-service > info > m... Systems Manual Finder. You will need your model number to locate the correct manual. Please follow the steps below or visit our interactive manual finder. ..

I would contact your service provider for the code.

Check Batteries: Ensure that the batteries are properly inserted and have sufficient charge. Sometimes, a low battery can cause the toy to stop functioning. Switch On/Off: Confirm that the toy is switched on. Some toys have an on/off switch or button that might accidentally get turned off. Connections and Wires: Inspect the wires and connections inside the toy. Loose wires or faulty connections can lead to malfunction. Obstructions: Look for any obstructions or debris that might be preventing the T-Rex's movement. Clear any blockages. Reset: If there's a reset button, try pressing it. This can sometimes resolve minor issues. Contact Customer Support: If none of the above steps work, consider reaching out to Fisher-Price customer support as below. https://service.mattel.com/us/ContactUs.aspx

You use a USB charger lead to charge the battery in the helicopter. The controller takes 6 x AA batteries. https://rc-today.ru/UserFiles/Image/Instructions/-S929.pdf https://www.google.com/search?q=rfd001+helicopter+charging+lead ..

It is too old (1970s) for that data to be on the Internet. There is one for sale on eBay, buy it and carefully look inside. https://www.google.com/search?q=Need+Play+%27N+Learn+Computer+420 ..