Razor E200/300 Electric Scooter Battery - Answered Questions & Fixed issues
My sons razor e200 dies quickly. I have changed
Problem is not the batteries then. Replace the controller. The controller could be resisting some of the charging current to the battery.
But first try this:
Charger the scooter with it OFF
Directly connect the charger to the battery
If still the same problem then:
Directly connect the charger to the battery then,
connect the motor leads directly to the battery and see how long it runs. It with new the batteries it should run longer than a minute. If it does than something is definitively wrong with the controller.
Razor e200 runs slow
This could be a sign of a dying battery, although it charges and lights the green light it cannot maintain enough juice to power the machine when it has weight on it.
How i can pump the weels on the back
Hi, you need to take the end-cap off of the right side of the handle bar. It is a black cap/plug that pulls out. You will see a black plastic piece that's about 3" long. Pull that out of the end cap. This is the extension that is screwed on the the air valve. Just place through the hole in the rear sprocket and thread on, and fill the tire with air. When done, unthread it and replace back into handle-bar end-cap and reinstall the end-cap. It only took me 4years to figure that out!
I have a razor e200. Nice physical condition.
Charge the batteries. If still no power than replace the batteries because they are dead. The batteries in the scooter need to be kept charged. If the scooter has not been charge in two weeks to a month and over. They are probably dead and need replacing. Find replacements at razor.com
Needs a fuse what type
There should be a name tag on the motor that tells the current (amps) that the motor uses. Such as 4.5 amps. You would then use one about 6 amps.
Bought a new battery for
take a look at the other one and see on which side the wire was hooked..on +or - or both where ...and just get some wires if they need to be longer ..and hook it in the same screw with the normal power line ..but remember from the other one ..which and where ..
How can I put chain back on my E200 razor electric
First your going to remove the deck.
Take off the chain tensioner
Next remove the motor and put the chain around the gear
Put the motor back on the scooter with the chain on
Then take the rear wheel off and put the chain into the gear.
Put the rear wheel back on along with the chain tensioner and deck
Your done!
Note: the reason why I say you have the remove the motor and wheel is the get the chain on. So you may only have to partial remove the motor or tires to get the chain on.
E20 razor rocket electric scooter will not charge
If it is a fuse problem then try looking for a fuse box in the controller or charger. If not then take it back, unless stated in the manual that you need to enter a fuse before it will charge, the scooter should charge right out the box.
Another thing you might want to try is to turn the scooter off before charging.
How do I test my batteries on my E225S Razor
Since the battery could put out 12v and still be bad your best bet would be to take the battery to Autozone or similar and have them do a load test (its free). This will let you know for sure if one or both of your batteries need to be replaced.
Not finding what you are looking for?