20 Most Recent Razor E100 Electric Scooter - Page 6 Questions & Answers

I'm afraid yes the voltage is far too low to run a Razor E100, the scooter needs the full 24v.

On the Razor E200 check the chain is fully tightened & lubricated & you will be amazed what incorrect tyre pressures will do (36psi) to the power of the scooter.

It is possible the new controller is defective, however just because the voltage is showing 24v it may not be outputting the correct amount of amps so don not rule out batteries before checking the following:
To test a battery you need to 'load test' so (with help) connect the battery directly to the motor when weight is on the scooter to see if it will still pull.
Please also remember that you do have to push the e100 to 3mph before starting (many users do not know or forget this step)

none

The batteries are dead. The battery in these scooter need to be kept charged or if not in use for a long time charged every 3months. Otherwise, like what to you, they will go dead. The chemicals in the battery have deteriorated to the point where it won't hold a charge. Replacement batteies are available at:

razor.com

how can it have a memory when it doesn't have brain? maybe you need to check your own memory

After charging use a voltage tester to measure the voltage from the battery the reading must be equal to what is the voltage output of the battery 12v or 24 volts if you can measure the correct out put voltage then the battery is full charge the scooter should work well.
If you measure a low voltage means you need to full charge first the battery before operating.
to measure the battery voltage put your red test prove to the positive terminal of the battery (red)and black test prove to the black terminal of the battery....If the battery is full charge and the scooter wont run there is a problem on the motor cleaning the carbon brush of the motor will solve the problem... good luck!if you need further assistance just post back!

Come on man....E100.

hi my son has not used the scooter for a while so i went to charge it and the green light comes on the charger straight away and the scooter is not working can you tell me what the problem is?

I had the same problem i replaced the battery and still nothing. Found that the charger was bad and reading that the battery was charges. Replace the charger. You can get them online fairly cheap

Replace the throttle. The throttle in these scooter are very cheap and wear out quick. You can find a throttle replacement at:

electricscooterparts.com

then kick that lil **** in the face or unscrew its vold and clean out its rust

The controller is bad. You can find a replacement at urbanscooters.com/partsforscooters

Fitted New on and off switch also new reset button. Battery ok but will not start