20 Most Recent Inverter Pure Sine Wave 1500w Inverter - Page 9 Questions & Answers

you need at least a 1900 watt inverter with a fully charged battery to run a 900 watt microwave,it uses 900 watts to make microwaves and it uses 700 or so to run everything else.

E-02 Inverter low DC/Battery voltage shutdown Battery voltage has dropped below 10 VDC for 12-volt units or 20 VDC for 24-volt units.

have it serviced,it is overloading a circuit.

this is a question for a qualified electrician or ring the store where you bought it from

Change the inverter for a mitsibushi hw94 is a 0,75 kw

You should contat Prostar http://www.prostarglobal.com/contact.php

battery problem

There are several ways to go, try the manufactures website, or if you have the skills, radio shack, allelectronics.com or mouser or digikey

First off you will most likely never find a schematic for any inverter. I have never seen one an they are closely guarded by the factory. Even dealers dont get them. If you study electronics a little you can service one of these things easily. It is really a switching supply. Once opened a compentent service man can repair one. All you really need is a good multimeter an knowledge.

You have to find the power consumption tag on the boiler and see what the amp and wattage requirements are. Then you have to look at the output capabilities of he inverter (watts and amps). Your load should be no more than 80 percent of the inverter.

Any electronic equipment service technician can do it. Gopakumar Gopalan Google

you did not give brand nor model, telepathy do not work as good as it is advertised in hollywood movies... just google "inverter repair wagga-wagga", solar/wind installers/sellers will be my first choice, they usually do repairs, but investigate first few prices what is equivalent on the market! repair sometime can be more than new item... if you are electric/electronic savvy, try to check what burn out and do repair yourself, if not - check if any of your friends will be an electrician or electronic technician, instrument electrician, all of them will have base knowledge how to check the item and how to repair it. hope this will help you, do not forget to vote...

Both, :) you should have glass fuses and when you buy them they will say 12 v 20 amps, But thats about the same as a 110 v at 2 amps maybe a little less, Look for what you have by reading the side of the fuse for the right amps.

840 watts if on 240 volts A/C

If you are talking about at KEB F4 inverter, error E.EF = External fault. This is a programmed response to a input signal or software condition.

LS = Low Speed. Check your direction and speed signals being applied to the control terminal strip

I think you are probably not going to have enough start up power for a microwave.They draw alot of amps on start up and I think your tv or dvd will pull about 1/3 to start.
I have a 8750 watt max watt generator and my wifes microwave is the only appliance in the house other than dryer that will make it change rpms.
Hope this helps you. Thanks

This internal fault code can mean so many things, but basically it more than likely has some internal parts that the smoke is no longer inside. They can be repaired however, email [email protected] to discuss further.
Thanks, Bob