NorStar Meridian M5009 Phone (NT4X35) - Page 2 - Answered Questions & Fixed issues

According to website checkwhocalled this is a phishing site

Date and Time

call forward ...feature 4 to the extn #

giggle the DND button if it is stuck, if no DND button press feature #85

the buttons are not programmed properly. Use 'feature * 0' to see what is on the buttons. press feature * 2, press the key, then dial the extension #. this will program the key with the proper extn #

feature 986

"Q: My Norstar Startalk, Flashtalk, or voice mail says my mailbox is not accepting any more messages. I deleted all my messages, but callers still cannot leave a message. Why? A: Check with your voice mail administrator. Chances are another Mailbox on the system used up all the message storage space. Usually it's the general delivery mailbox that hasn't been checked for messages on a regular basis." Frequently Asked Questions The following discussion suggests that voicemail can be inactivated, and cab be re-activated by logging in and pressing '4' Startalk Flash Won answer Nortel Phone System Tech Support This says that the mailbox must be initialized. http://www.uniquecomm.com/docs/Startalk_Flash_Quick_Reference_Guide.pdf

I would just COPY the settings from another extension that is the closest or same as what you want... F**CONFIG ... Terminals&Sets ... (enter "good" extension #) ... COPY softkey ... (destination extension) ... System&User ... and you're done.

Feature 3 or Transfer if you have a hard or softkey

F**TIME F**8463

A model number would help. What # phone, what # expansion box"?

First you have to check your service provider if you have activated this service because here in South Africa it cost a nominal fee for caller ID

should you dial 9 or another access code for outside calls? If if you dial an "outside" number on an intercom line it will look at the first 2-3 digits as another extension. You need to dial the Central Office access code, or use a line key assigned to an outside line.

Feature * 0 then press an intercom key.

Do you have a dial tone?? Try dialing 9 then number..

It is probably made that way, but if it wasn't like that out of the box first plugged in, than there should be a button to make it brighter. (or it might just be you...)

This would depend on if the line is a stand alone line only being assigned to one extension or on a PRI having DID service. Do a Feature *0 and check the line buttons. It will show the line number or target line number. With this information you can check it in one of two ways. If it is a stand alone line and provided a line number, access the line by pressing the line and dialing your cell phone to get the Caller ID information. If it associated with a PRI having DID service, you will have to check the target line information in programming. A system administrator or vendor needs to do this.

The lines have been restricted in the phone system for some reason that might not be needed anymore. Check with your Phone System Administrator. A system vendor can make these changes or an administrator with programming knowledge.

The only way a password will stay with a phone is if the "Extension Relocate" feature is turned on. This means that when the phone is moved from one desk to another it retains the same extension number. To verify this do a Feature *0 and press the intercom button to view your extension. Now move the phone to another desk and repeat the process. Passwords are related to the voice mailbox and there are verbal commands using the dial pad to make any changes. Usually 1 is for yes and two for no or 1 to change and 2 to accept. Not knowing which voice mail system your have it is hard to give anymore detail.

Most likely you can swap the phones. On older systems it might not work so I would try one first. You do gain extra buttons which can be programmed as desired. Any buttons you had on your M7310 would be on the T7316e. You can check the buttons by pressing Feature *0 this will allow you to check any button on the phone.