20 Most Recent Aube Technologies Aube 7-Day Programmable 40-500w Light Timer Switch - Page 2 Questions & Answers

http://www.uheat.co.uk/aube_th132_underfloor_heating_thermostat.htm

TH132 is a thermostat for under-floor heating
Go to the website above and download on-line copy of your manual
On-line manual let you read bigger print & lets you break down the steps easier

I am sure by the time this answer reaches you, the problem will be solved
This is true because manuals are frustrating, until you tell somebody it can't be figured out >> which gives you time to rest >> after which the manual makes sense.

BUT I am frequently wrong, and you may be at a standstill
A quick look at the manual.
You can also select which part of the manual is giving you a problem and then I will help you through that specific difficulty

Wiring: I guess the instructions at bottom of manual apply to your model
Your 240Volt hot wires from breaker box connect to terminals 1 & 5
Your two wires supplying power to heat connect to 2 & 4
Pilot wire to terminal 3
Floor sensor to 6 or 7 >> wire from sensor can connect to either pole
The TH132 has two sensors, 1 located inside the TH132, the other sensor located in floor

Set up:
The first part describes 10 buttons (right away you know this is complicated)
There is a brief description of both sensors
Step 1 shows how to configure the start and temp-display switches

Step 2 covers installation of module on base
I guess you hook up power at this point because the display is supposed to light up
This implies that the bottom part of manual should be located more towards the top, and the power-up directive seems to be missing. Bad manual.
Step 2 shows what the display looks like with first power-up

Step 3 tells how to set current time and day.

Step 4 adjust temp setpoints >> floor temp is pre-programmed to 82 degrees

Step 4 shows that you press-and-hold the sunshine or moon button to have it display
The sunshine button is the upper temp setting, the moon is the lower temp setting

Step 5 is operating mode > choose automatic for programming to operate

Step 6 is programming, which carries on with about 24 steps
If this is your problem area, let me know
Now the manual suggests you make a chart of your programs
Other programmable devices don't work when there is a conflict in programming

Wow I see the TH132 is 'equipped with a proportional adaptive controller..' that carries a two year warranty. I'm sure you'll rest easy knowing that.

Reply back with the specific trouble area, and we'll get it going for you.

Normal 0 false false false MicrosoftInternetExplorer4 /* Style Definitions */ table.MsoNormalTable {mso-style-name:"Table Normal"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-parent:""; mso-padding-alt:0in 5.4pt 0in 5.4pt; mso-para-margin:0in; mso-para-margin-bottom:.0001pt; mso-pagination:widow-orphan; font-size:10.0pt; font-family:"Times New Roman"; mso-ansi-language:#0400; mso-fareast-language:#0400; mso-bidi-language:#0400;}

http://waterheatertimer.org/Aube-timers.html
http://www.aubetech.com/products/list.php?noLangue=2&noFamille=5&app=13

Links above shows 10 different Aube models
Select your model, click link next to your model, next page has instruction manuals at bottom of page
Each model has different instructions
4 models are 7-day timers
4 models are sunrise-sunset timers
2 models are combo sunrise-sunset
There are 2 exterior box-type timers with choice of sunrise-sunset or 7 day, depending on model
The instructions vary by model

Let us know if you have problems with specific instructions

www.smarthome.com/4256W/Aube-7-Day-40-500W-Timer-White-TI032-3W/p.aspx
pdf is there

You didn't mention the specific model of your timer, but here's a link to a manual that I hope will work for you:

http://www.aubetech.com/manuel/2/TI032.pdf

I have also had the same problem with 2 units. I have been in touch with Aube who say they have identfied a problem with the back unit which they will have fixed in " a few months time". My suggestion would be to contact them for a replacement later on this year

http://waterheatertimer.org/How-to-set-timers.html Link above can help Gene Water Heater Timers Save Money If you need further help, I’m available over the phone at https://www.6ya.com/expert/gene_9f0ef4df2f9897e7

Timer not identified http://waterheatertimer.org/Aube-timers.html http://waterheatertimer.org/How-to-troubleshoot--timers.html Gene Water Heater Timers Save Money If you need further help, I’m available over the phone at https://www.6ya.com/expert/gene_9f0ef4df2f9897e7

do you have a model number

This is old timer since it still uses batteries.Replace AAA batteries.This timer also has preset programs. User cannot change preset programs which is the strangest thing I've ever heard about a timer, except vacation timers. It appears the timer turns on-off 6 times each day for no apparent reason that shows in manual.Moreover, the timer has very complex instructions, whereas other timers are far easier to program.Buy another timer. If you need further help, I’m available over the phone at https://www.6ya.com/expert/gene_9f0ef4df2f9897e7

Aube technologies has a page with thermostat manuals
http://www.aubetech.com/products/list.php?noLangue=2&noFamille=1&app=1

Thermostat page shows 3 models for your TH132 (toward bottom of page)
Click the model number and it opens a second page
The manuals for each product are conveniently located on that second page, toward the bottom, along with a description of your product.

In my opinion, Aube (Honeywell I think) website is way ahead of the curve for customer convenience
Most other electric device websites have manuals located on a different page than the product
A lot of sites, like Leviton, have no manuals at all. Lose the manual, and you have to call their customer service like in the 1980's
Aube must want your repeat business.

• When the switch is ON, the light operates in dusk-to-dawn mode. In this mode, the light automatically turns on at sunset and turns off at sunrise. When the switch is off, the light stays off.

motor or gear failure

It sounds like the button contacts aren't making good contact. If you can get behind them you can spray them with electrical switch cleaner. ..

Press P (program )on the timer and display will show then change the desired day, time and minute using the D+, H+ and M+ buttons. Press P again to set up another program and repeat the second step as above

Clear memory by pushing the reset button on the timer then reprogram using your current schedule when you want the timer to go off/on. Use the day and clock buttons for this then press enter

No, the timer should not make any noise. The noise should be a result of loose connections which cause arcing, which can make a humming or buzzing sound. If you find that you still notice the sound, even when the main breaker is off then the problem is not electrical in nature.

Question edited for clarity and add a header in order with spaces and CAPS. It appears Micromark got out or the timer business. There is a similar one in another Fixya post, and a link to them. https://www.google.com/search?q=Micromark+MM+9565+timer ..