20 Most Recent Siemens HE2415U Electric Kitchen Range Questions & Answers

The only diagrams I could find online were at the following site, in the manual:
http://dl.owneriq.net/9/950820db-087c-4c06-8610-296dae3425cf.pdf
You will probably have to contact Bosch for more detailed diagrams, and here is their site:
http://www.bosch-home.com/us
If you can find a local shop that services Bosch, you may be able to get them to show you the diagrams on their computer.
The title says Siemens, but when I googled it, it came up Siemens on some, and Bosch on others, but I think Bosch may have made it for Siemens, since the parts sites said Bosch, and the only diagram/manual was for the Bosch.
Anyway, hope this helps.

Error Code 43 Cause: Upper (or single) oven motorized latch will not unlock; Defective or jammed upper oven door or latch switches; Defective latch motor or its wiring.

solution:

1.Check connector on the power board.

2.Ensure door latch switches are operating properly.

3.Check that neither latch switch nor common wires are
pinched to the appliance chassis.

4.check if latch motor wire is pinched to the appliance chassis.

5.If 43 persists, replace power board

Grill aint level

ok, just attach the meter to the elements contact terminal post. after this is done, you will need to select a temp and activate the heating cycle as if you where preparing the oven to cook. You should get reading during the power up, if not, your control is bad. if you get readings at the elements terminal post and the element dose not operate or glow, you will need to replace the element.

1. Access SELECT FUNCTION menu
2. Turn knob clockwise until desired language is displayed
3. Touch start to accept a language change

To access SELECT FUNCTIONS menu, touch and hold COOKING MODE touch pad for 5 seconds

SELECT FUNCTION is displayed:
1.Turn knob to desired feature
2.Press START to choose any function, and turn knob to choose any sub-functions
3. After selecting feature, touch OFF

I did some searching, but could not locate a good source for fault codes for a Siemens range. I suspect, however, that you have either an Electronic Range Control (ERC) or Control Panel problem. In most ranges that I have had experience with a constant beep with flashing error code indicates a fault with either one of those two components. Don't quote me on this, though. Most appliances have a tech sheet located in them somewhere so technicians will have something other than the owner's manual to troubleshoot with. The tech sheet on a range is normally located on the back of the range, or somewhere inside the lower drawer/kick plate under the oven door (if equipped). The tech sheet SHOULD have all your fault codes. What Siemens recommends is to press the OFF button to clear the display and the beeping. I suspect you've already tried this. If the problem persists you're supposed to call for technical assistance. If all else fails Siemens has a a number you can call for assistance: 866-44SIEMENS (447-4363). Good luck and I hope this helps some.

I have exactly the same issue on my Siemens hob. It is weird and no one seems to know the answer. Anyone? Si

You should really use a qualified gas technician on all gas appliances. https://www.google.com/search?q=replace+the+broiler+igniter+on+a+siemens+hg2415uc ..

It sounds like it may be a failing thermocouple/safety valve. These are 2 components that allow gas flow to the burner as they heat up. They do fail as part of the 'wear and tear' but are cheaper than a new oven. Good luck!

Control board fault. Did you try turning it off then back on? You will probably need to replace this part or get a service tech.

Find out the model number, then search for: Make Model manual