Top 20
Coleman 10' X 10' Sundome Tent 9160K101 - Page 3 Questions & Answers
What kind of oil do I usd in my powermate 5000
Use SAE Grade 5W30. Use syntheti or regular oil but do not mix the two. The unit holds about 22.5 ounces so you can drain what is in it and start fresh if you want to switch over to synthetic. Engine wise the synthetic will last longer. Joe
My heater on my coleman electric fireplace Model
HI,
Sorry for my english, I,m french. I'm from Québec, Canada.
I have the same problem with my fireplace. Same model.
Do you have the manual or the papers who came with the fireplace. My electrician need it. May you scan or fax to me?
Thank you very much.
Jacques Blanchet
Fax: 1-819-762-0130
email:
[email protected]
I have a Coleman model FL 28-R electric fireplace,
There is a fuse located over the heating element in front of the fan.
It sits over a small slot above the heating element (probably to cause
it to stop working by design). Yes I'm a pessimist. It can be bypassed
if it is an emergency by wiring across it. I'm trying to find the
replacement fuse now (10amp jet 250v #00575) If you find it please send
info to
[email protected]. I hope we all get our heaters working,
for $250 + dollars you'd expect it to last longer than 1 month.
I have a coleman powermate 6250 generator it get
Lets see, Do you have any ether or old school lighter fluid? If you use ether spray a little into the air intake just before you pull the cord for a start, if it starts you have a carb problem. Same for the lighter fluid, remove the spark plug and squirt a small amount down in the cylinder, again if it starts you have a carb, probelm. Take the carb. off the engine take note of the rods and springs, take a picture get it in good focus so you can put it back together. Take the fuel bowl off the bottom of the carb and clean the jets and all see if that will help.
Centre pole is failing to hold tent up in any real wind
TRY DRILLING A SMALL HOLE ON THE INNER POLE SLIGHTLY SMALLER THAN THE DIAMETER OF THE SCREW. U WILL WANT TO DRILL SMALL HOELS EVERY FEW INCHES(CM) SO THAT U WILL BE ABLE TO SET THE POLE AT VARIOUS HEIGHTS IN THE FUTURE.
We need help with setting up coleman 13x9
General tent setup instructions:
thread assembled poles through sleeves
connect one end of poles into tent corners
1 by 1 connect the other end of the pole, work front to back and the tent should assemble quite easy.
My coleman eletric fireplace does not work, the
There is a fuse located over the heating element in front of the fan. It sits over a small slot above the heating element (probably to cause it to stop working by design). Yes I'm a pessimist. It can be bypassed if it is an emergency by wiring across it. I'm trying to find the replacement fuse now (10amp jet 250v #00575) If you find it please send info to
[email protected]. I hope we all get our heaters working, for $250 + dollars you'd expect it to last longer than 1 month.
I have vertical cracks at the location of the
It cracked at the seat bracing starting at the screw holes due to
expansion and contraction of the plastic polyethylene. The heating and cooling effect is caused by storing it outside or worse directly in the sun. Go to
www.bullseyetradingpost.com they have a simple fix for this, you should be back in the water in short order,then store it out of the sun.
How to light coleman lantern
Kerosene lanterns require a little more than just lighting the mantles. Go to Coleman's website and find the directions (for free) for KEROSENE lanterns. The generator on the lantern needs to be preheated with alcohol before it will actually light. Make sure lantern is a Kerosene lantern and not a white gas (Coleman fuel) type, there is a difference even though they look similar.
Not finding what you are looking for?