20 Most Recent Coleman 2 Burner Propane Stove 5430E700 - Page 3 Questions & Answers

Hello,
Here is a PDF with the assembly instructions for your tent as well as a PDF with instructions on how to care for your tent.
Assembly instructions for Eureka Tetragon 1210 8 man Tent -http://store.eurekatent.com/media/document/TETRAGON121009IM.pdf
How to care for your tent - http://www.eurekatent.com/detail.aspx?id=47
regards, Tony

I have the same issue. It looks as though the rivets broke off. I have yet to reattach the slide mechanism. Normally the slide mechanism is stopped by a peice of emtal about 1./2 the way down the slide. Either new rivets or some flush head screws might sole your issue.

I don't believe a spotlight will do that.

Coleman Camper Manuals TRY ABOVE Phone Number

800-835-3278

Average Wait: 42 mins - 24 hours, 7 days Contact Coleman Shortest Wait Best Support

I think you can found it on amazon, here: Amazon com coleman replacement lamp .I hope this was helpful. cheers

This camper uses the Coleman lift system which uses a threaded rod that connects to a tracked distribution block to which all four cables are connected and then routed by pulleys to all four corners of the popup.First raise the popup to it;s full height by using automotive jacks and poles once extended securely clamp the poles to the telescoping up rights This IS SUPER IMPORTANT FOR YOUR SAFETY. Next get under the camper find the broken cable unbolt it's routing pulley(s) pass the broken ends out the pulley(s).Next unbolt the end from the distribution block. followed but unbolting the cable from in side the telescoping column;carefully note the routing in side the column. Buy or make up an exact length cable of aircraft grade stainless steel twisted wire cable of the same gauge. Reverse steps to re install,take lowering strain on crank make sure crank handle is captured by anti free wheeling device on camper un clamp poles remove, lower and raise top by crank to ensure smooth working. You're finished.

http://www.analogx.com/contents/vinview.htm

One is available for download from http://www.popupportal.com/manuals/Coleman/Coleman_1982.pdf

Here's what worked for me

Press and hold the following three buttons in sequence: PROGRAM - MODE - SET DOWN. Once all three are being held down, the lock symbol will disappear; and the control functions are unlocked. =0 )