20 Most Recent kawasaki Full Suspension Mountain Bike Men - Page 5 Questions & Answers

I think if its an electrical problem then you should check the fuse. It might have burned out you can tell if that has happened by seeing that the metal wires in the middle aren't touching then you have to replace it with a fuse with the same number on top. Their not expensive at all and you can find them at your local hardware store.

Maybe if you could look it up on a search engine you could find one i found a lot of manuals by searching them or just go to the manufacturers website and look for it on there.

Until it is hard except on a hot day because the heat will cause it to expand and pop like mine did.

good chance u have a bent rod, bent valve. Need to take to shop to get checked out.

Just loosen the oil cap and then loosen the bleeder untill steady stream comes out the bleeder. Top off with oil replace cap and thats it . Good luck

Hello,

you will need to check all the wires that connect to the battery to see if none is shorted, because this could be a short circuit wire problem, check all the wires to see is any is defective, if any, replace it.

Take care.

Hello,

The belt light that is on is causing the problem.

Thanks

Welcome to FixYa
Have you Checked Oil level..a
Here is the Service manual for your Model here{you can Download it for Cheapest Price].there you can available all Service guide for your Vehicle..
Thanks for Contacting FixYa

This bike does needs a battery to fire the coils for spark to the plugs to start it up

buy a bottle of gasline anti-freeze. it will absorb any water in your fuel. add a half a bottle now and a half next time you fill the tank. should improve the operation of the engine

I hate to tell you this but we go by hrs. the motor has ran for if theres not a hr.meter on the jet-ski you well need to istemate on how many hrs.it has ran.If you think maybe the water impeller needs to be replace,it won't hurt.better to replace then be stuck.

how long was your bike sitting for when you did the new piston? change the old fuel out the tank if the bike has been stood for along period of time the fuel may have gone off. have you installed the piston the correct way round?

you do know this is mountain bike
they have no motor

just downlaod lalnation bot

The identification plate on cycles is up on the steering bearing mount forward of the fuel tank. I’m happy to assist further over the phone at https://www.6ya.com/expert/gregg_78ecbb34e27be215

If you disconnect the neg while it is running, you risk damaging the regulator, check the battery voltage with a meter.
Just over 12v engine stopped
13v or more engine revved