20 Most Recent Dewalt Heavy - Duty 18 Gauge 2" Brad Nailer Kit Reconditioned - D51238KR - Page 3 Questions & Answers

This is a common problem with this compressor and still is a problem in 2014.It is under powered and trips the reset

copy and paste in search engine. took about 5 seconds to find answer. Dewalt Air Compressor D55146 Belt Replacement

Without inspecting tool, it would be hard to definitely tell what part, I would call Dewalt, they will be glad to help you. You do not want to throw parts at it. 1-800-433-9258

either not properly closed or latch damaged

DeWalt DWFP12233 Manuals

If previous nails worked, they sold you the wrong nails.

Contact customer service at dewalt.com. Be sure to have your model and serial numbers ready, as wiring diagrams can change during a tool's production run.

From your description it sounds like the bearings on the armature seizing up . Mainly the bearing on the bottom towards the pad. I see it a lot . It'll seem ok when turned on but under a load it can stop , slow down , smoke ....I'd start by checking the bearings. If it was the cord power would cut in and out completely. It doesn't have a variable speed switch or any speed sensors on that model. .if you have any questions feel free to ask and give as much detail as possible plz.

reading the user manual reveals that it requires oil before using and regular oiling during use that is simply attained by disconnecting the air line and putting a few drops of machine oil in the connection and reconnecting the air back up that oil then lubricates the seals and piston of the machine do that and it most likely will work again

Google it or utube

DeWALT DW433 Type 1 3 21 Variable Speed Belt Sander Parts And the correct tools

find out what thread direction the screws are before going brutal---an impact driver may have to be use to remove screws---don't know if they used lock tight on them or not from factory---impact driver is a tool that you insert in to the screw then rap the end of the driver with a mallet/hammer---this action keeps the screw bit buried in the screw and twists at the same time after being hit----this will work only if there's no lock nuts opposite the screw (other end).----GL

Trigger may be stuck try a little singer oil or sewing machine oil only a few drops should do it... trigger switch may not be working properly either

try pushing the front roller in towards the back it is most likely a spring loaded arm that when pushed back will activate a trip lock to hold it back after fitting a new belt release the trip lock spin the belt by hand and use the knob that you were turning to center the belt on the pulley if you do not do that , then on starting the belt may run off the pulley

WHAT ISSUES ARE YOU HAVING WITH THE UNIT

Just take apart the knife and get knife out reassemble it and then put the knife back in