Price Pfister Marielle Kitchen Faucet with Matching Spray and Soap ... - Answered Questions & Fixed issues

If you just installed it check to see if it has a water saving feature that in some homes and almost restrict all the water force

there may be garbage in the strainer. unscrew the strainer where the water comes out and check the screen inside there. it could have a partial blockage

HI, parts can be found from amazon (entire assembly too), take a look here: Amazon com price pfister marielle kitchen faucet parts. Wish you best of luck. Cheers

if your faucet is new....the spout was put together wrong and it needs to be removed and re-attached correctly...(friction washer/ring in wrong position).....if not new....spray some penetrating oil on the connection that is supposed to swivel....make sure the surface is dry and try to avoid overspray. let it sit for 15 min...then spray it again...and again let it sit ....after sitting for a few minutes.....gently try to move the spout side to side...if no change...repeat the first processs...and continue to repeat until it becomes moveable....once moveable....detach the spout.....dry out and remove any foreign matter from the connection side on the faucet...then apply a small amount of faucet grease to the connection threads and the inside barrel....a thin even coat ...excess grease will clog your aerator...don't use too much....now repeat the cleaning and lubricating process on the removed spout connector....reassemble.....remove aerator....turn on the water and flush....replace the aerator....turn water on full blast....check for leaks and for swing...it should swivel now ....if not...loosen the connection nut a tad and try again....if still no swing....you are missing a friction ring somewhere in the connection and it needs to be replaced before you will be able to swing the spout.....good luck...

water is supposed to come out of your faucet...in a controlled fashion....if its at the handle....remove the handle and locate the source....tighten the packing gland or replace a seal. if it sprays all crazy at the spout...try unscrewing the little piece on the tip of the spout (aerator)....flush your faucet by running the water with it off...then flush out the screen on the aerator and re-attach it...hope I was some help....good luck and always know where and how to turn your house water supply off before working on any pressure points on your water supply system.

Replacement parts can be found on amazon. Click here Watkins Hand Soap Made Naturally Since 1868 and take a look. I hope this was helpful. Cheers

Either you didn't seat the o rings properly or they are the wrong size or the cartridge needs replacing

LOOSE PIPES ARE WATER HAMMER.

YOUR WATER PIPES ARE NOT FIRMLY MOUNTED,IF A PIPE MOVES IT WILL MAKE NOISE,NO MATTER WHAT FAUCET YOU HAVE.

I will need a few more details. Can you post a pic of what you are looking at?

How did you resolve the problem of removing the spout assembly? We also have a Price Pfister 34 series kitchen faucet and are trying to replace the diverter. Like you, we have removed everything down to the spout assembly, which will not simply lift off. We have tried letting it sit overnight with WD40, thinking it would loosen it up. No such luck. Then tried using white vinegar, thinking maybe there were calcium deposits holding it on. No luck. Please tell us that you were successful and how you got the victory over this stubborn thing!

I also needed to remove the "hidden" flow restricters from my Price Pfister Parisa Kitchen Pull out faucet. The hot water side had never flowed the same as the cold side. Now both sides are flowing the same as should have been all along.

Is the plate damaged? If so you should be able to get another at the hardware store. Will it slip over the sprayer? If not you will need to turn the water off at the cut off and unscrew the sprayer hose the pull hose through the sink hole and put the plate over the hole then the hose goes back through the hole and screw it back on under sink. It should be good to go.

You need an aerator wrench, Pfister part number 941-031. Several vendors on the web carry this part.

Hi. Did you know you can find and order parts on the Pfister website? If you prefer you can email us and our customer service team will reply. Please provide: * The model number of the product. If you do not know this, please follow these directions: http://www.pfisterfaucets.com/do_it_yourself/how_to.aspx * A method to contact you (phone prefered.) Please send this information to us at [email protected]. We apologize for your inconvenience and look forward to resolving this matter as soon as possible. Sincerely, The Pfister Team Pfister is a part of the Stanley Black & Decker Hardware and Home Improvement (BDHHI) Group.

Unscrew top button. Using a phillips screw driver remove handle retaining screw and work off handle.If it leaks under the handle you need to unscrew the top cap, use a strap wrench to hold the body and tighten the brass retainer ring with an adjustable wrench. Or remove the ring to replace the cartridge.

It is screwed in. You have to remove the head on the spray, then remove the faucet.

try un-screwing the screen on the end where the water comes out. Could be clogged

wow need a new faucet?? NO just kidding

Ok the water not running out of the faucet. that is the screen on the end of the spout, just un screw it clean it and your good to go.The leak on the spray, pull the spray out and run it and look at the connection right there on the handle.

if there is no leak, get an other person to run the sprayer and you take a flash light and look up at the bottom of the faucet.and see if you can see the leak from there. The hose should attach to a brass section coming out of the bottom of the facucet, It may be it just got loose and you need to re tighen it. Now yo will need a basin wrench to do that . If yo dont have you you can buy a cheap on ( which is all you need) from a hardware store,

Also if you take your hand and feel around the the bottom of the sink where all the pipe come down it might be the fauect itself.

Good hunting be safe protect your eye

Tom

no you have to take the sprayer all the way off and replace the broken coupling

Sorry we could not give you a quick fix

Tom