20 Most Recent
Lexmark X4650 InkJet Printer - Page 3 Questions & Answers
Paper will not feed
Hi, maybe there is still a little bit of jammed inside that you can\'t see. Try to see if there is and clean it. If you\'re sure there is no paper jam whatsoever, then there is a conflict with your feeding sensors or your cartridge isn\'t properly installed.kind regards
How to find the PIN number to scan for a Lexmark
Hello,
Unless you have setup a PIN for scanning when you installed the printer the default PIN is 0000. If you setup a pin and don't remember, go to the Lexmark Productivity Studio, click on setup and diagnose printer, then on left side select Advanced, another screen will pop up click on Networking and another screen will appaer at the bottom there is a link that reads Change your PC name and PIN for network scanning, click there and you should be able to see and/or change the PIN.
Good Luck and don't forget to rate this answer.
Is this a free fix?
You can just download the printer software/driver that you need from the manufacturers web site
Only printing 7%
If you're using Windows, it could be that your Print Spooler is not running properly. Please follow the steps below to fix the problem:
1. Browse to Start -> Run... and type in NET STOP SPOOLER (this will stop the
print spooler service)
2. type in NET START
SPOOLER (this will restart the print spooler service).
Try to print a document again to verify that the problem is fixed.
My lexmark x4650 printer is
When you installed your printer, you had to install the software on your PC. So go to your PC's start menu, go to Programs, select Lexmark software, select Tools and then select Wifi Configuration Utility. It will open a window which will give you step by step instruction on re-configuring your wifi settings. When you are doing this, make sure your printer is connected to your PC via the USB cable.
Black cartridge error
First, check to see that a toner cartridge is in fact installed.Open the toner access panel and remove the cartridge. Check to see if it is indicating that it is empty. If so, replace the toner cartridge and wait for the error message to clear as the machine prepares the new cartridge for printing.
Lexmark Pro 705 won't let me print after refilled
If you refill the regular lexmark 100 ink cartridges, you will not be able to use it because there is a rfid chip that track the ink usage. you will need to buy the 100a type which will let you print if the ink level is empty. since you have refill the 100 ink cartridge, you can swap the 100a chip to your 100 cartridge.
Printer is not 'seen' by
I have written a small selection of articles on making a printer show as online for different operating systems. They can be found
here.Any further issues please don't hesitate to let me know.
Not finding what you are looking for?