20 Most Recent HP Laserjet CM 1312NFI Color Printer - Page 2 Questions & Answers

Hi
Have you tried reinstalling the firmware for the printer. If it is already loaded on your computer then you should be able to reinstall the firmware in order to get it booted.

hope this helps (ie if you haven't gotten it fixed already)

I hope you did calibration..The Flat cable from laser scanner assm to DC controller is very short & narrow, while connecting it to DC board little bit it will come out at scanner assm PCB, remove upper portion up to laser scanner assm refix flat cable both ends of DC & laser pcb. fix all back & try.. I hope it will resolve the issue.. Best of luck...

Welcome to FixYa.

• Verify that the input tray is not overfilled. The input tray capacity varies depending on the type of print media that you are using.
• Verify that the media guides are properly adjusted.
• Check that the input tray is securely in place and it is the default feeding tray.
• Do not add print media into the input tray while the product is printing.
• Use only HP-recommended media types and sizes.
• Do not fan media prior to loading it in a tray. To loosen the ****, hold it firmly in both hands and twist the media by rotating your hands in the opposite direction.
• Do not let print media stack up in the output bin. The print media type and the amount of toner used affect the output bin capacity.
• Check the power connection. Make sure that the power cord is firmly connected to both the product and the power supply box. Plug the power cord into a grounded power outlet. Check for any small objects that might have caused a jam from the input tray and the rear output door.
  Keep me posted. Jas247

Hi
If you still need some help in this, I will be putting up a link soon. Hope it resolves your issue

Hi
What operating system are you using this with?

Sorry but I don't understand your question. I hope you have gotten your issues resolved, if not simply post your question and I will try my best to answer it.

Hi
I will be posting the link to this question soon...I found a video which was very helpful

Hi
What operating system are you using this with?

What operating system are you using?

51.2300 Yellow scanner laser error

The product has experienced an error in the scanner sub-assembly area.

Turn off the power by using the power switch, wait at least 30 seconds, and then turn on the power and wait for the product to initialize.
If the error persists, verify that all formatter connectors are firmly connected.
If the error persists, update the firmware.
If the error persists, replace the scanner assembly.

Please select the operating system and download the drivers

http://h20000.www2.hp.com/bizsupport/TechSupport/DriverDownload.jsp?prodNameId=3558903&lang=en&cc=us&taskId=135&prodTypeId=18972&prodSeriesId=3558902


If you satisfy with my solution please rate/vote for me.
Rating/Voting will encourage me to help others

Click here and select the correct operating system and you will be able to download the complete install. It will be listed under the software category.

Hi

I suggest you to printer preferences or properties and choose the correct setting there like uncheck the GRAYSCALE to print in color.

Go to printer icon, right click mouse and choose either printing preferences or properties.

If not, there is also option in the printer preferences to choose RESTORE DEFAULT SETTING.

If still not solve, set up once more the printer and print the test page.

I hope it helps you . Post comment if you need more help. Regards

You should try to restore the computer to previous datewhen it was working all fine.. this link should help you doing that.. Howto restore the computer to a previous state