20 Most Recent LG DLE2514 Electric Dryer - Page 5 Questions & Answers

You will need to replace the control panel. The button is pressed in the down position and won't allow you to do anything else till this part is replaced.

You have a bad motor and needs to be replaced.

could be a number of things,, is it the house fuse or the machine fuse? check this link out http://www.partselect.com/dryer+dryer-wont-start+repair.htm

Hi,

If your dryer is not drying like it once did or if you just have nottaken the time to give yourself a clean dryer in a long time then youneed to do that. At least once a year the dryer cleaning should takeplace. Lint build up in the dryer duct is one of the main causesfor your dryer to fail.

Here is the rest of this tip about DryerMaintenance

heatman101

Hi,

There can be many reasons why your dryer will not start or turn...

The most common causes are the belt breaking or jumping off, or the motor goingbad...

Here are a couple of tips that I wrote will help you to figure out why yourdryer will not run...

Dryer Repair - The Dryer is not Turning

Dryer Repair - The dryer will not start


heatman101

;'

';

do you mean a condenser dryer?, as steam is water doesn't dry anything to well, if it is a condenser dryer the check filter or clean filter light should always come on towards the end of the cycle (varies between models some have both clean filter and empty tank lights on at end of cycle just as a reminder to do so and some don't have any lights), it is simply a reminder for you to clean the filter after each use unless this is something that has only just recently happened

disconnect the vent tube run dryer with a load of clothes

Hi,

There can be many reasons why your dryer will not start or turn...

The most common causes are the belt breaking or jumping off, or the motor goingbad...

Here are a couple of tips that I wrote will help you to figure out why yourdryer will not run...

Dryer Repair - The Dryer is not Turning

Dryer Repair - The dryer will not start


heatman101
';;'

Hi,

There can be many reasons why your dryer will not start or turn...

The most common causes are the belt breaking or jumping off, or the motor goingbad...

Here are a couple of tips that I wrote will help you to figure out why yourdryer will not run...

Dryer Repair - The Dryer is not Turning

Dryer Repair - The dryer will not start


heatman101

The most common problem for a dryer to take more than one cycle to dry is restricted air flow.

1.when the dryer is running go outside and find where the venting is located, there should be a good amount of air flow.
2. if the air flow is not good look at the ducting coming from the back of the dryer and make sure it is not kinked or pushed back to far.
there is usually lint build up some where along the ducting or at the end of the duct where it vents to the outside.
3. if you have access to a leaf blower,this can be used to help clear any lint build up inside the duct from the dryer to the outside venting.
move your dryer out and take the leaf blower tube and stick it in the hole and turn it on.
the vented louvers need to be removed from the ouside of the house to allow the lint and things in the duct work to be blown out.

Hi,There can be many reasons why your dryer will not start or turn...The most common causes are the belt breaking or jumping off, or the motor going bad...Here are a couple of tips that I wrote will help you to figure out why your dryer will not run...Dryer Repair - The Dryer is not TurningDryer Repair - The dryer will not startheatman101 ][][\

Hi,

If you are having problems with your gas dryer not heating the most common problem is that the ignitor goes bad. Even though it glows sometimes it is still not working properly.

if you dryer is gas check out this gas no heat tip....

If you have an electric dryer, you can have many different things that can go wrong causing the dryer not to heat.

check out this electric no heat tip...

heatman101

././

The Child Lock feature is activated and it can be deactivated by pressing and holding the DRY LEVEL button for 3 seconds or until the CL display is cleared.


Indicate the exact model number of the dryer if the control panel doesn't look like the one shown above or if no button with the small "PRESS & HOLD 3 SEC TO SET CHILD LOCK" (DRY LEVEL) marking is found.

Hello,

I have provided you a link to a repair website that has an excellence article on how to access the inside of this dryer.

http://www.appliancerepairlesson.com/2011/01/12/how-to-access-lg-dryer-dryer-breakdown/

Hi

Assuming it as LG DLE2514 Electric Dryer CL means the Child Lock has been activated to avoid any harm to the children. To reset the dryer you'll need to press and hold dry level for 5 seconds. Hope this helps...please post back for further assistance.

Daniel

the heating sincer went bad.

Oreck Clean Home-2505 South 38 st.,Tacoma,Wa (253)474-8440.Pochel's Appliance and Mattress,14001 Pacific Ave., Tacoma,Wa,(253)531-1040.SEARS Parts and Service,817 East 72nd St.(800)366-0006.Trading Post,14620 Pacific Ave.,South Lakewood,Tacoma.Mr.Appliance,8805 East E St.,Tacoma.(253)536-7500.You can try the local Tacoma yellow pages for more choices and whats near you.

Please check the power and controller for malfunction then

Hi,

If you are having problems with your gas dryer not heating the most common problem is that the ignitor goes bad. Even though it glows sometimes it is still not working properly.

if you dryer is gas check out this gas no heat tip....

If you have an electric dryer, you can have many different things that can go wrong causing the dryer not to heat.

check out this electric no heat tip...

heatman101
..........................

Hello & Welcome to FixYa

If everything else in the dryer is working fine and it won't heat so it means that the thermal fuse which is located inside the rear panel on the blower wheel housing is bad and needs replacement. Please get back to me if you have any other questions.