20 Most Recent American Standard 2294.011.020 Afwall Elongated Wall-ADA Retrofit Toilet - Page 9 Questions & Answers

There is a clog in the line. A plunger usually solves this problem, but you have to use a toilet plunger. Your local hardware store will give you the right tool ($13). If the plunger doesn't work, you need a toilet auger (also called a closet auger), which you can buy for less than $20.

replace float assembly

The brown ring is usually caused by hard water stains. With bit of chemicals scrubbed with a scouring stick. Toilets are fairly cheap if you need a new one for better looks.

most likely the chain that comes from the handle is holding the stopper.so just give the chain a little slack.

Shut the water off flush toilet and there should be two bolts that you can see at the under side of that tank. You need to remove them bolts and lift off the tank and install a new seal. Sometimes i mean sometimes you can tighten them a little and they will stop leaking. If it has been for awhile id just replace it. I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_a3369546f8067589

Check the aerators for debris. Aerators are located at the end of the spout where the water comes out. Usually these unscrew counterclockwise (some models require a tool). Rinse out and reinstall. They may be just a lower flow model.

I haven't sat on your toilet, so the rockin' don't come from me! Our grandpa had a habit of slamming his a@@ down on the toilet here at my house, so now it rocks when sat on. The bolts have shifted, or the wax ring was smisshed. If you take off the toilet from the floor, and find out either/or, let me know.

I seen two tpyes one where the inter jet unscrew and the other where the outter ring unscrews not sure what kind you have . Went to the pool store and they had a cleaner you add to the water and then run the unit for about 20 minutes then drain . It seem to work pretty good and there was less hassel taking the jets apart

Configure