20 Most Recent
Whirlpool Safety Bath Walk In Bathtub - Stretch Without - Page 6 Questions & Answers
Whirlpool jacuzzi tub one jet not as strong as the other 5
I had the same issue after mine was installed. The line to the jet in the back was crimped a little and when the crimp was taken out, it works just fine. The line that was installed was a little to small and it did not have room to fully expand. You might check this out and I hope that it is the same as mine. Easy cheep fix buy just getting a little bigger line.
Jets in whirlpool tub not working
If its on a GFCI circuit reset switch.Air button activation - check for loose air tube connections or bad air button.Electronic control - contact a spa technician for diagnostics. If the error is not electricity to the pump or the button(s) controlling the pump - it is likely a bad pump.
My spa will hum when
Hi,The pump seized up or the motor bearings went bad and seized up...Bottom line is that you will need to remove the pump and motor and take it apart to figure out what is causing the problem....heatman101
I have a corner whirlpool
sounds like you need maybe pump union o-rings, part # o-49 or the seal might be leaking. If the water is leaking between the plastic wet end and the motor then it is definitely the seal kit which costs about $30 however on a bathtub most pump mfg have quit making replacement parts for them. You will most likely need a new pump in that case. If you can let us know what brand of pump we can assist you in repair or replacement.
US Parts Center
We have a whirlpool tub with jets and the mice
All of the parts of a Whirlpool tub are replacable. you can go to Whirlpool.com and call customer service to get part #s and order or you can patch the hose with applicable materials from a home repair store such as Home Depot or Lowes.
Hi I have a jacuzzi.
You can get 2 types of Jacuzzi baths, 1 with just a pump which just jets the water via a small pump or 1 with the pump and elements that heats the water aswell as pumps the water through the jets. Because the 1 with the elements has a higher amp rating you need to run a cable from your distribution board to your bath but the 1 without the elements you will be able to tap off the nearest socket to the bath, you will be coming from your socket to a fused spur outlet, it would be better to get a switched fused spur outlet as you will be able to isolate the bath when not in use just by switching off the switch. from the spur outlet you will be wiring it into your motor on the bath, it should say the rating of the pump in amps on the tally plate of the motor or on the manual. For example if it says the motor draws 2 amps you will be putting a 3 amp fuse into your spur outlet so if there is a fault with the motor the fuse will blow instead of tripping the whole socket circuit. All jucuzzi baths has to be connected to the RCD side of your distribution board. If you are tapping off a socket don't worry about the RCD because all sockets should be on the RCD anyway, to check that the socket is connected to the RCD plug something into the socket you are tapping off of and press the test button on the RCD, the RCD should trip and while this is tripped check the lamp or whatever you plugged in shoud be off. The Fused spur should be fitted outside of the bathroom.
Not finding what you are looking for?