20 Most Recent
Whirlpool Safety Bath Walk In Bathtub - Stretch Without - Page 4 Questions & Answers
Black flakes from jets
It is biofilm growing inside your plumbing. The black flakes are most likely biofilm. Check out specific cleaners designed to remove that crud. The best is called OH YUK
Black debris is coming out
If the tub is more than 5 years old the rubber pump impeller could be disintegration.
If the debris just seems to be dirt then fill the tub above the intake with HOT water ... then add some dish washing detergent to the water ... run the pump about 1/2 to 1 hour
The push,turn on control has become very difficult to push on and off what can i do?
Disconnect power from the system. 2. Purchase a can of www.ultra-lube.com (This type f lubricant will not cause breakdown of rubber, silicone or plastic seals) multi purpose lube. HomeDepot sells it. Black green and silver spray can. 3. Remove the knob using the right size Allen wrench. 4. Spray lube into the neck of the actuator. 5. Wipe off any lube from the knob shaft. 6. Re install the knob and push pull a few times to distribute the lubricant. 7. Restore power and test system.
If this does not solve the problem then there may be a mechanical failure in progress. Go online at the manufactures website to order a new switch. Btw, I’m available to help over the phone in case u need at
https://www.6ya.com/expert/john_28069c9efb56199d
Not finding what you are looking for?