20 Most Recent
Whirlpool Pearl Ballade True Bathtub with Back Massage - 100463-100 - Page 4 Questions & Answers
MY WHER25 REV. OS. IS LEAKING AT THE HOLE IN THE
Remove the faucet spout and unscrew the screw keeping the white plastic piece on the bottom (of the faucet). It's where the red and black tubes enter. Pull out the white plastic with the tubes and clear it of debris (usually placed there when your disposal backs up the black tube, which serves as the filter's drain tube). Once it is cleared of debris, make sure the black rubber washer is back in place (it may be stuck in the faucet, so look for it) and replace the plastic, screw the screw back in, and secure the faucet again. I had this same problem and doing this solved it. Should take about 5 minutes or so. Good luck.
Helena hw4272 by hessco
Not sure where you are from but I have a Helena that we are replacing that has a good pump and motor. You may be interested in it even for parts.
I own the Wher25 Reverse Osmosis system. I
There is a blue cap on the body of the white pressurized water tank. Twisting off the blue cap, you will see a air nozzle - similar as those on the tire. You need to pressurized the tank to 60 PSI. I spend hours to figure out this solution on my own system.
11/15/2013 7:52:57 AM •
Home
•
Answered
on Nov 15, 2013
My washing machine will not
most likely there is a switch that is burned out. on the lid there is a peg and that peg goes down in the hole and triggers the switch to let the machine know the lid is closed. romove the front panel (should just pull off) this will expose screws to remove top. switch will probably have burn marks on it. replace it.
Air jets wont turn on
- Check the circuit breaker to make sure the power is on at the controls.
- Check power coming out of the control going to the air blower
If there is no power coming out of the control when it should be then you have a bad control box.
Rod Kidman
US Parts Center
We locate the "seemingly" impossible...
Ph: 888-521-6183
Fax: 801-417-8027
"Chat Live"
Whirlpool jacuzzi tub one jet not as strong as the other 5
I had the same issue after mine was installed. The line to the jet in the back was crimped a little and when the crimp was taken out, it works just fine. The line that was installed was a little to small and it did not have room to fully expand. You might check this out and I hope that it is the same as mine. Easy cheep fix buy just getting a little bigger line.
Not finding what you are looking for?