20 Most Recent LG LRFD25850 French Door Refrigerator - Page 3 Questions & Answers

The reservoir inside has to be replaced. After numerous calls to LG, I finally got the LG Mobile Service Tech to service it, and the water reservoir has been completely redesigned....can you say "design flaw?" Now, since the new "tube" has replaced the "reservoir," I have little green things floating in my filtered water! I hate LG products.

Unplug the unit. What is the display panel showing?

Switch is bad on the refrigerator.

Economy mode. If the door is used less than a certain number of times a day the power consumption is lowered by switching the compressor on less. It is a good thing, not a fault!

It might be something simple like the water faucet is not open all the way

LG FRENCH DOOR SERVICE MANUAL
If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

If you have water in front of the refrigerator often your drain hole is frozen over and not allowing the water from your defrost cycle to drain into the drain pan. You can manually defrost this by disassembling the rear of your freezer and using a hair dryer. I would suggest that you simply unplug your refrigerator make sure you prop the doors open and allow it to defrost for at least 12 hours. http://www.on-timeappliance.com/refrigeratorrepair.html

We need to find the reason for the restriction of cold air from your freezer making its way to top of the fresh food section. Because cold air is heavier than warm air you will get these symptoms for several different reasons. If you do not already have Adobe Reader you can get a free download here=> Adobe Reader X (10.1.1) Just uncheck the box if you do not want a Google Chrome download. Click here for a=> LRFC22750 Service Manual Then Click Here=> LRFC22750 Parts Manual The components listed in the parts manual begins with a photo page and part location numbers. You will need to scroll down from page 1 to page 7 below this photo page that begins with the location numbers and to the right the model number has three columns each different part number follows below in each column.

I want you to look for any signs of frost build up on the rear wall of your freeze. If yes the symptons are listed below as the most likely reasons that will cause this to happen

SERVICE DIAGNOSIS CHART

for your model can be also found on page's 13 and 14 of your models Service Manual Possible Causes Symptoms: Frost or ice on evaporator.

1. Defrost thermostat faulty->Check defrost thermostat. Replace if failed.

2. Evaporator fan faulty ->Check fan motor. Replace if failed.

3. Defrost control faulty ->Check control and replace if failed.

4. Defrost heater remains open -> Check defrost heater continuity. Replace if failed.

5. Open wire or connector -> Check wiring and connections. Repair as necessary.

6. Refrigerant shortage or restriction -> This will look very different than a totally frosted over evaporator. As Freon slowly is lost the evaporator may appear to have ice on half of evaporator as the leak becomes worse the ice melts and cooling is affected more until there is no cooling. Click here for what that looks like=> Lack of FreonUnderstanding the way LG uses part numbers is tricky at times so ask if you need help with part numbers or questions about Controls that are likely the reason for the symptoms you mentioned in your post. Ask if you need I will be here to answer any questions you may have, rate if helpful and please ask if you need more answers, Thanks John Tripp/ AKA Sea Breeze

:
Hi!
A relay starts the compressor with a higher voltage and then quickly kicks out
It does a lot of clicking (trying to start over and over again)
If thats what is happening with yours
Its best for a tech to replace The relay but you can do it
Take your model number to your Local Appliance parts store they will have a diagram
showing you how to install the relay. Its called a hard start relay
I use part no ERP410 POWER START RELAY, CAPACITOR AND OVERLOAD all in one. (110 v)

If you still have trouble Go Here:

http://www.applianceaid.com/procedures.html

Thank you for using fixya
Leo Ponder
PLEASE VOTE FOR ME IF THIS WAS HELPFUL