20 Most Recent
Balboa Instruments Duplex Digital Panel 2 Pump - Page 2 Questions & Answers
My hot tub is getting power but I cannot get
you may have a circuit board error that is not allowing you to operate the controls or the top side may need replacing.
try locating the back up battery on circuit board and resetting it to restart your memory, does not always work but worth a try.
normally a J45 jumper, is marked on circuit board
Adam Miller, Canadian Spa Company, UK
1/7/2014 10:12:53 AM •
Balboa...
•
Answered
on Jan 07, 2014
I have a Balboa control board system (M2000
It sounds like it is 120/240 volt and that one of the lines is not working. Try turning off the breaker and turning it on again. You may have to use a tester to see where the fault is.
10/17/2013 6:31:24 PM •
Balboa...
•
Answered
on Oct 17, 2013
Hot tub wont come on
What do you mean "Jump it"?Check with a meter, ACROSS both hot wires to get a reading of 220-240 volts. do not test across 1 hot and the meter lead on ground! You probably are not getting proper voltage to the hot tub. Or you may have a burned system fuse normally 20-25-or 30 amp fuse, which is found within the control box of the spa.
1/16/2013 6:45:57 AM •
Balboa...
•
Answered
on Jan 16, 2013
How to fix balboa EL2001 spa
Hi,OHH would be the Hi Limit sensor. OHH is an overheat event...Check the followng:1. Low GPM.
2. Low Water Level.
3. Blocked Suction Fitting.
4. Blocked Skimmer.
5. Dirty Filter.
6. Too Many Closed Jets.
7. Closed Slice Valve.
8. Heat Related Pump Not Running.
9. Heat Related Pump Not Primed.
10. Malfunctioning Impeller.
11. Incorrect Heat Related Pump.
12. Circ System Misconfigured.
13. Sensor Malfunction.As you have already changed the sensor it is likely to be one of the others points. Hope that helps.
10/31/2012 9:11:39 PM •
Balboa...
•
Answered
on Oct 31, 2012
Not finding what you are looking for?