20 Most Recent Hitachi EC12 Portable Electric 2hp Air Compressor, Oil Lubricated - Page 9 Questions & Answers

notify a dealer or manufacturer

First, you have to determine how it is attached usually they are screwed or bolted into place or simply held into place by clips or pressure. But there are many different models so please post the model of your machine so it can be identified or even a photo.

This is a common problem with this model - the typical reason for this is overdriving the piston which is usually caused by air pressure being too high. It can also be from using it on thin or soft wood (using it to nail plywood to plywood etc)

This is not replacing an o-ring, unfortunately, this involves replacing the manifold #887-499 which contains the regulator. There are no regulator parts available.

check and test cut out may be faulty or failing

If u are talking about the bleed off that blows when the compressor shuts off. It should blow down for a short period then stop. If it dont stop your tank check valve is bad.

There is no battery on that air compressor.

So the first (most obvious but sometimes overlooked) thing - check to make sure the tank drains are closed. Listen for a leak at the pressure switch - it will continue to leak after the compressor shuts off. If this is the case then you need a check valve (Part # 53A on the breakdown) If it builds pressure but not enough to shut off and there are no leaks I would look at the valves located in the head (Part # 14 on the breakdown) - piston rings are not a normal failure part on this model but could also cause this.

This problem is usually caused by reed valves or blown gasket between head and valve plate. Easy to check. After the compressor reaches 45 to 50 psi, with compressor still running, remove the air filter and feel for good suction at the intake port. If the air seems to be blowing out of the intake, then valves are bad. If you feel good suction at the intake, then air is leaking from the discharge tubing or other fittings. Good luck

8 ounces of Synthetic Oil SAE15W40

Pressure gage A shows the pressure in the tank. Pressure gage B shows what you have adjusted the output pressure to be. If it is reading 0psi and it is new it is probably because the manufacturer has set it at that level. You have an adjustment valve on the front of your compressor. Rotate it until you see the pressure start to rise then keep going to where you want it set at.

Hitachi EC119SA 15 Amp 2 5 HP Lon Twin Stack Air Compressor Instruction...

here is a link to maintenance for these good luck Hitachi EC119SA 15 Amp 2 5 HP Lon Twin Stack Air Compressor Instruction...

Hitachi EC12 Portable Electric 2HP Oil Lubricated Air Compressor Parts Replace the entire regulator. You buy parts but you will be money ahead to buy a new one.

insure that there is no debris ie., free from filings from the nails used or or ceck the feeder ports where the nail enters before it lives the port ( check for damage orifice or abstractions to it

To remove the fan you will need a decent bearing puller - it is press-fit onto the armature shaft and doesn't come off easily.

canon leserjet lbp 3150 error de service e100 0000

recheck the "O" rings for one rolled over or nicked when assembling put a small screw driver blade under the "o" rings and travel around the piston several times to allow the ring to settle in properly

A lot of the compressors I have had were discontinued before I ever received them. I know what ordering the right part can be like. If you can give me a description of what the part does or where it is located I will brain storm with you to find a work around. If you leave a comment it will email me.