20 Most Recent HP Compaq Presario CQ50-110US Laptop - Page 5 Questions & Answers


You're not really turning it off.
You're putting it into standby mode.
Press and hold the power botton down until the screen goes blank.
Once it has shut down completely, press the power button as usual and it should start up.

HP Compaq... | Answered on Dec 26, 2010


Hello.

The most common reason is the power jack.

If you wiggle the cable where it connects to the laptop and the power goes on and off, the power jack (inside the laptop) needs repair or replacement.

If no change, remove the battery and try to power on with the A/C. If it works, your battery needs to be replaced. if it doesn't work, your power adapter probably needs to be replaced.

Hope this helps.

HP Compaq... | Answered on Dec 22, 2010


1st check if the wireless driver is installed on the computer if the driver is not installed then go to the below link

http://h20000.www2.hp.com/bizsupport/TechSupport/DriverDownload.jsp?prodNameId=3752688&lang=en&cc=us&taskId=135&prodTypeId=321957&prodSeriesId=3739787

Choose the Operating system and download and install the driver and you should be able to get connected if that does not work then try the below mentioned steps

Go to control panel, switch to classic view (continue if you are already in classic view). Double click Network and Sharing Center, on the left panel, Select Manage Network Connections, Right Click on the Wireless Network Connection and click Enable

HP Compaq... | Answered on Dec 21, 2010


Shut down your laptop and try pressing the center of the keybord just center of your screen firmly gently and then start the system if its ok the display comes back you are having problem with the heat sensor of the display card and not coooling properly .so loosing the display.
BUT if you mean there is a cursor blinking on the screen and dosent have display then your boot devices are configured improperly and so its searching for boot device .
also it happens when usb boot is enable in the bios and any usb device is connnected like flash or usb hard drive try to remove them and restart the pc.

HP Compaq... | Answered on Dec 13, 2010


hi
Im Kapila from Sri Lanka.
to solve the noise like a siren,
open the sound mixer (double click on the speaker icon on the task bar) and mute the mic on that, or decreas the mic level.
its OK, you can adjust it the audio settings perfectly via double click on the audio icon in control panel.
not enough the details for flickering problem.
send the message to kapilarl@yahoo.com regarding that

HP Compaq... | Answered on Dec 05, 2010


you can contact sizcom calicut,they are best in laptop servicing,their contact no is 0495-4040768,09846558977

HP Compaq... | Answered on Dec 01, 2010


The Inverter is what goes out 90 percent of the time.

An LCD screen cannot produce enough light by itself. It needs an additional light source.
A Backlight is used to provide the additional light source.

A Backlight is a CCFL. Cold Cathode Fluorescent Lamp.
Similar to Fluorescent bulbs, (lamps), use in homes, and businesses, but on a Much smaller scale.

An Inverter is used to provide power for the LCD screen, and the Backlight.

A laptop's power source cannot provide enough power for an LCD screen.
The Inverter does.
A laptop's power source provides too much power for a Backlight.
The Inverter reduces the power.

An Inverter slowly goes bad as a general rule.
A Backlight goes out all at once.

An Inverter is a small circuit board located in the Display Assembly.

The Display Assembly generally consists of the top cover of the laptop, the LCD screen, (assembly), the Backlight, Metal frame going around the LCD screen assembly, the Inverter, Wireless Antenna, Bezel, and various fastening screws.
(The LCD screen is an assembly. It consists of layers, held together by the above mentioned metal frame)

The Bezel is the thin plastic frame that surrounds the LCD screen, in the front.
Once the Bezel is removed, you will have access to the Inverter.

As I am sure you are aware, HP bought out Compaq.

HP Support > Compaq Presario CQ50-110us Notebook PC > Manuals,

http://h10025.www1.hp.com/ewfrf/wc/manualCategory?lc=en&dlc=en&cc=us&lang=en&product=3752689&

On this page I would like you to scroll down, and click on the Service Manual > (Free, and in PDF file form),

HP G50 Notebook PC and Compaq Presario CQ50 Notebook PC - Maintenance and Service Guide.

This is a PDF file. After you click on the above file name you won't see anything happening right away.
The file is downloading in the background.
(I downloaded this file just now. Took 4 seconds to see the first page, and an additional 41 seconds to fully download. Watch the Download Progress Bar, and let the file download all the way before looking through it)

In the Bookmarks menu to the left, click on the + sign next to > Removal and replacement procedures
Now click on the + sign next to > Component replacement procedures
Finally scroll the file tree down a little bit, and click right on > Display assembly

[ You may wish to reduce the view size to 125% or 100%. Go to the top header, and click on the Zoom Out icon. ( - ) ]

Page 61 in the PDF page number box shows you where the Inverter is located.
(Top header to the right of the blue down arrow)

BEFORE you start:

1) Work on a table
2) Remove ALL power to the laptop. Remove the AC adapter (Charger) and Battery

3) It would be advisable to buy, and wear an ESD wrist strap. (Electro Static Discharge)
Connect the alligator clip to a good ground source.
(I connect to the metal frame of an empty desktop computer case, for example. You may have an object that is similar)

The cost of an ESD wrist strap averages around $3 to $6. An economical $3 ESD wrist strap will do just fine for this one-time procedure.
[ Your body carries Static electricity. Static will fry out (Short Circuit) the hardware components inside a computer. An ESD wrist strap connected to a good ground will keep your computer safe ]

4) Use a multi-compartment container for the various screws you will remove. label the individual compartments for the area the screws came out of. Some of the screws look VERY similar to other screws. You Don't want to mix them up.
[ You can use a clean egg carton in a pinch. Label each egg holder ]

5) After all power is removed you have to remove in order;

A) The WLAN Module. Page 49
B) The Keyboard. Page 52
C) The keyboard Cover. Page 54
D) Then the Display Assembly

From a quick search, for an Inverter for the Compaq Presario CQ50-110us Notebook PC,

http://www.nylaptopparts.com/index.php?main_page=product_info&products_id=883

For additional questions please post in a Comment.
Regards,
joecoolvette

HP Compaq... | Answered on Nov 15, 2010


Welcome to Fixya.
The driver for the Cyberlink webcam can be found here.
  1. Just click on the .exe file to begin download.
  2. Go to Downloads folder.
  3. Click on the .exe file to begin installation.
Hope this helps. Cheers!

HP Compaq... | Answered on Nov 11, 2010


Hi there!

To further check your laptop hardware, you need to bring it to a service center.


Regards,
fossildude

HP Compaq... | Answered on Nov 09, 2010


You need to integrate the SATA drivers for your computer in the XP installation CD using the nLite program.

Follow this guide:
http://news.softpedia.com/news/Install-Windows-XP-On-SATA-Without-a-Floppy-F6-47807.shtml

HP Compaq... | Answered on Nov 05, 2010


Only if you have BIOS password set. In the past, BIOS passwords can be reset by removing batteries and shorting pins. But these days, the NVRAM chips that holds the passwords needs to be physically desoldered and replaced, which makes it very difficult and costly.

Windows passwords can be cracked easily. Hard drive passwords are also near impossible to crack and protects your data, but hard drive can be replaced easily making the laptop usable.

So if didn't have BIOS password set, then you're pretty much out of luck.

HP Compaq... | Answered on Oct 25, 2010


Try some here -->link,

thumbs back!

HP Compaq... | Answered on Oct 24, 2010


Hi.
Based on the information you have provided, the issue might be due to the Windows Temp files or due to any Virus.
First, we can try deleting the Windows Temp files.
We can do this be performing the Disk cleanup.
I have mentioned the link which has the detailed steps to perform the Disk cleanup.
http://support.microsoft.com/kb/310312
Please click on the above link to view the detailed steps.
Performing the Disk cleanup should resolve the issue.
If the issue still persists even after performing the Disk cleanup, then the issue might might also be due to a Virus.
However, you may try performing a complete System Scan by using the Anti-virus Application installed in the Computer.
Please perform all the steps mentioned above.
This should resolve the issue.
Hope this helps.
Please feel free to contact for further information and assistance,

HP Compaq... | Answered on Oct 23, 2010


Please follow the diagnosis outlined in this article to check whether the backlight lamp or the inverter board are the root cause of the problem or not:
http://www.fixya.com/support/r6430776-troubleshooting_laptop_power_failures

If you connect the external monitor & nothing is displayed on it, then this means that both the backlight lamp & the inverter board are fine. The main indicators in these cases are the sound, and the hard drive LED on the laptop case. If the laptop sounds just like it always does for a minute or two after being turned on, it means it's going ahead and booting the operating system, but the video processor or part of the motherboard circuit for video output has failed. If the laptop just sits there and beeps when you turn it on, or if you hear the fan but not the hard drive chuckling with its active LED flashing away, it means the laptop isn't getting as far as trying to boot the operating system. While this could be due to any number of hardware problems, the most common and easiest to
troubleshoot or repair is RAM failure. If your laptop has two RAM modules installed, try booting with just one and then the other in the primary slot. If your laptop only has one RAM module, you might consider buying one online from a site with a good memory selector, like Crucial.com.

HP Compaq... | Answered on Oct 19, 2010


i would expect to see the compaq logo come up, and you should be able to "post" (ie bring up the bios or a diagnostic screen) even if there is no functioning hard drive.
at least I would expect it to pop up with something like operating system not found,
you might be better off replacing this one (sorry)

HP Compaq... | Answered on Oct 18, 2010


i had this problem on a certain brand of laptop,i finally refered to the owners manual to find FN-F5 toggled from the screen to external monitor depending on 1 click or 2 etc and that Fn-F1 put the screen into sleep mode the same way---im not suggesting your machine uses the same sequence keys but it might be worth a try finding out if you have accidently toggled your keys.
you could also be missing your OS or your bios boot sequence is incorrectly set--Press F2 whilst booting to get into boot sequence option of bios)-there navigate with tab or arrow keys--save and exit or reset settings to default and exit--dont change any thing in bios settings until you are familiar with how to navigate and select changes OK!

HP Compaq... | Answered on Oct 02, 2010


If you touch the laptop while it is running & you find it too hot, make sure that the fan is running properly & that the air ways are not blocked.
You can blow compressed air into the cooling vents of the fan. If you notice clouds of dust coming out, then it might be a good idea to disassemble the laptop, clean the fan & air ways, & reassemble it back. If the fan has failed & is no longer running, it might need to be replaced.

If none of this solves the problem, or is not the case, then you might have a bad motherboard.

HP Compaq... | Answered on Sep 28, 2010


Look at the screen at a shallow angle and look for any 'ghosts;' images that you might expect to see during boot or after.
If you can discern anything, then it could be a failed back-light (fluorescent) or the inverter for it which is customarily on a single small board that is obviously connected to the display/cover half. This is potentially user replaceable with care and a few small tools.

HP Compaq... | Answered on Sep 25, 2010

Not finding what you are looking for?
HP Compaq Presario CQ50-110US Laptop Logo

229 questions posted

Ask a Question

Usually answered in minutes!

Top HP Computers & Internet Experts

Ekse

Level 3 Expert

13434 Answers

Les Dickinson
Les Dickinson

Level 3 Expert

18429 Answers

Thomas F. Schneider

Level 3 Expert

2715 Answers

Are you a HP Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Presario HP

  • Presario HP

Most Popular Question

compaq cq58 laptop charge

  • Computers & Internet
Loading...