20 Most Recent Canon iR 2016i Black and White Copier - Page 5 Questions & Answers

Replace thermistor at the fusing unit. Also, the fixing film may need replacing, or the entire fixing assy - depends on the wearing.

Could be just dirty scan glass.Maybe the drum unit,transfer roller or fixing film

The fuser has a problem. The error refers to affixing film displacement error. The mylar sleeve over the heating element in the fuser has probably shredded and needs to be replaced.

Sir, there doesn't seem to be an error code accounted for that reads E30. Canon IRC 2100 Service Repair Manual That is the link to the service repair manual which also has the error codes so you can diagnose what is going on although there doesn't seem to be an E30 code accounted for. This is a more extended list of all of the error codes and once again there seems to be no E30. There are 9 pages of error codes if you'd like to look. Error Codes Canon iRC2100 page 1 Perhaps a mistype?

The finisher output guide is usually a small plastic piece about as long as the paper feed that can be opened to see the rollers, make sure that is put back down before you print.

the e001 code is something is going with the fixing assembly. one of the thermistors could be going bad.

E808 is a Zero Cross error. We most commonly see power supplies or bad wall voltage cause this code.

The following information is coppied from the IR2016 Service Manual.

E808-0000 DRIVE CIRCUIT FAILURE
A zero crossing signal cannot be detected.
A fixing drive motor failure has been detected.

E808 0000 Fixing drive circuit failure

• The heater does not turn on.
• A fixing drive motor failure was detected.
• Check the connector of the fixing film unit.
• Replace the fixing film unit.
• Replace the fixing drive motor.
• Replace the DC controller PCB.
• Replace the power supply PCB.

M201 - Fixing Drive Motor - FK2-1067 - J202 on the DC controller PCB - E007, E808

Power Supply - FK2-1074

https://www.google.cl/#q=thermistor+photo

Whenever I experience data error with my photocopier machine, this is what I do. 1. unscrew the machine from the back panel removing all the plastic casing. 2. Get a blower and a dusting brush and clean all the dust particles and tonner that has fallen on the circuit board. 3. brush off the dust particles from the sensors and use a blower to blow off the dust. 4. Perform an indepth cleaning. 5. Re-assemble all the parts that was taken off. 6. Power on the machine. I hope this will work.

the sistem error

You probably have a problem with the bootrom and need to call a canon tech to have them reflash the bootrom firmware