20 Most Recent
Canon iR 2016i Black and White Copier - Page 4 Questions & Answers
I have Canon iR 2020
conon ir2020i can not innitiallise asking to switch off and on the main power switch
The proplem was ,( Open
Hi,
do you have two drawers?
On second drawer there can be problems with pick up clutch, but... first thing first.
When you open the drawer cover, you will see one plastic vertical guide for paper, when you press it it lifts up the paper sensor flaper.The flaper must be in the midlle position of slot on these plastic quide.If it's not apply some wd 40 on edges of guide and on the flaper and left edge of the flaper.
Manualy push the guide and while holding it close the door.
Hope that helps!
If not keep me posted, with details.
Download Standby
- The internal firmware has become corrupted; re-flash it
- or call Canon and request a download for the original firmware to your printer
- or visit their website to see if it's available that way
Error E007
Dear
This error arises due to the rotation sensor of the sleeve at fixing assy. The fixing film assy.to be replaced or the film (to minimise the cost)may be replaced if the heater contact points are ok.
If problem still found check the rotation sensor .
Thanks.
Canon ir2020 system error E007
Hi,
For the E007.
Did you put back the green jam release lever when you replaced the film.
or did you add a printer kit.
For the E007 check if the new film is rotating in the same speed as the presure roller, check if you mounted the film sensor corectly, and if the sensor is reading the corect end of the film ( it schould be the one whit a white square on it).
Please revert me, if you need more assistance, i would be very glad to assist you more.
If you were satisfied with the solution please rate this sollution.
Thanks For using FixYa!
Vinod Kumar J
Firmware for canon 2016
You need a special program in your computer called service tool,on which is firmware,Connect your printer with computer and download firmware
Not finding what you are looking for?