20 Most Recent Canon iR 2016i Black and White Copier - Page 2 Questions & Answers

E000007-0000 code is Fixing Film error.
FM2-3346-000
1 FIXING FILM ASSEMBLY 120V
FM2-3353-000
1 FIXING FILM ASSEMBLY 230V EXCEPT CN
FM2-3329-000
1 FIXING FILM ASSEMBLY 230V CN

E007 means that the fuser film inside the Fuser unit is damaged which needs to be replaced, or the white patch on the fuser film is dirty and it just needs to be cleaned. I recommend getting a canon technician to fix it,

I'm assuming it is the waste toner full message. Power down copier- Main Power. Open front door and gray handle to open left side door and pull out drum. On the top there should be an opaque disk to be removed and then you can dump the waste toner into the trash. BE VERY CAREFUL THIS COULD GET MESSY.! Slide the drum back back into position, close the left door and front door. Power up the copier and all should be good.

The only thing I can think of, without actually seeing it work, is the feed rollers. I've never liked the feed system on this model, seems to be very temperamental. It could also be the feed clutches. There was a modification that should have done years ago dealing with the feed system. I don't know if this applied to the extra two cassettes but the two upper paper pick-up assemblies were to be replaced. Gears were updated.

hi;
you should download a new software, use SST and the new software for IR2016i.

It is either the drum unit or developer unit or transfer roller. if your counter is 150 000 copies change dev unit and transfere roller.

check print controller pcb connection, ram & EEPROM

The main motor is faulty. try to replace it

your problem is the term zip code is american postal code is a more generic search term this site below will assist your quest http://www.sapostalcodes.info/

Additional Functions button>ID System Settings>Initilize All Data Setting tab. This may take a while to process do not power down during this time.

talk with the principal of the school

take out the developer unit and check it for broken shutter or mixer rod.

hi there

first replace the drum (i.e the photoconductive cylinder)
I wish you solve the problem.

thank you and not forget to vote me any how.

i have
contact me in my e-mail

[email protected]