20 Most Recent Fisher and Paykel WL26CW2 Top Load Washer - Page 7 Questions & Answers

Switch off power & unplug from wall socket. Leave for a few minutes then restart. If it has not cleared the problem, call out an expert to diagnose. Could be either a display board fault or main control board fault.

check pump is not over heating a common fault on these,they overheat and once cool down go again

RPS (Rotor position sender) fault. The RPS is an electronic sender unit mounted on top of the motor winding. It tells the main control board what position motor is at for it to start properly and also if motor is actually running. Replace the RPS.

usually means it need a repair or service,check the drain pump is ok and not blocked or jammed also when empty push down on the centre of the bowl it shouls have a good resistence to being pushed down if its really soft then replace suspension rods

maybe it could be the board is not crrectly in place so look at that first

faulty pump or blown board

You need to be more specific. There are 5 wash lights and two rinse lights. Each have a different number value when working out the error code. Count from left and say what number light is on. Spin being the 8th light from the left.

Error code 40 40. (00101000) Inner Basket Disengage Fault While carrying out a basket check, the Motor Control Module has found that the basket is not engaged even though the pressure sensor indicates that the tub is empty. The Motor Control Module continues to check for 2 minutes, after which time it displays this fault. The first two areas to check are the clutch and the pressure tube. If these two appear correct, then the fault could be in the pressure sensor in the Motor Control Module. Primary Source: Mechanical. Action: 1) Check that there are no clothes or other foreign objects preventing the clutch from re-engaging. Excessive suds can stop the basket rotating. 2) If the machine is empty of water, carry out a clutch disassembly procedure (Refer to section8.14) and check the spline drive. 3) Next check that the pressure tube has not come off and that it is not kinked. Secondary Source: Motor Control Module. Action: Replace Motor Control Module. 8.14 Removal of Clutch Mechanism (Spline Drive / Spline Driven) (a) Follow the procedure for removal of Inner Basket. (Refer to Section 8.13). (b) Remove the 3 screws securing the spline driven to the inner basket. Reassembly: Refit in the reverse manner. Ensure that the screws are tightened sufficiently with out over tightening.

Blockage in drain pump. You will have to empty water out with a jug. Then get machine outside and remove drain pump so last of water comes out. Check for any rubbish in pump, then put pump back and test it.

15.5 Size Setting If a new motor control module is fitted, the size switch settings will have to be set in the memory. To size set a L.C.D AquaSmart™ machine: 1. Press and hold the left SCROLL button, then press the HIGH EFFICIENCY button until two beeps are heard. 2. Press the SCROLL button to select the machine size (600 for WL70, 650 for WL80). 3. Press the POWER button.

removing bowl is the best way

you can buy lint filters from f&p but your main problem is caused by something like a tissue or something like that disintergrating inside ur machine best thing to do is remove inner bowl and thougherly clean both

you will need to remove the inner bowl and clean it all

check pump for burnt windings,if good faulty main computer board

its probably the rotary position sensor,it would help if i knes what lights are on at the time

check drain pump for burning smell sniff it or and discolouration of the copper windings