Jack Lalanne Health Master 100 8-Speed Blender - Page 4 - Answered Questions & Fixed issues
My blender is not turning on anymore.It is all plugged into the outlet and it doesn’t seem to power on anymore.
This problem can come from both the blender and or even the circuit powering it. First make sure that the outlet you have your blender plugged into is powered and not ripped If your blender still is not turning on then you may have a faulty motor or motor connection. Or the fuse could be blown and needs to be replaced.Or it could also be jamming for this you must first need to disassemble the drive and then turn the blade shaft. If it seems to be stuck or jammed here check what is the causing it to be jamming. In most of the cases it is debris that are stuck in the blades of the blender that causes it to be stuck.
11/30/2020 2:26:06 PM •
Blenders
•
Answered
on Nov 30, 2020
•
262 views
Cooks Blender Thermal Fuse Where is it on the motor?
The thermal fuse must be in intimate contact with the motor so when the motor temperature climbs dangerously high the fuse temperature doesn't lag far behind.
I have seen the thermal fuse buried in the windings of a transformer so it isn't beyond the realms of possibility it could be inside the motor. The thermal fuse body is metal and live and so must be insulated and so is generally found in the supply wire inside some heat resistant sleeving strapped firmly to the motor...
8/9/2020 7:46:00 PM •
Blenders
•
Answered
on Aug 09, 2020
•
113 views
Why won't my ninja blender turn on? The red light is blinking, but power is connected and lid is secure.
try rotating the container part 1/4 of a turn to line up slots and press down . then if it does not blend turn another 1/4 turn to line up slots and press down pushing container into base motor unit .
container and screw on blade lid is put in upside down and the plastic posts have to match the base unit to turn on the blender when you press down on container into base unit.
I own and use a ninja blender !.
7/4/2020 7:21:44 AM •
Blenders
•
Answered
on Jul 04, 2020
•
4,971 views
Ninja Blender 1100 starts then stops almost immediately, is there a way to fix this?
It Could Be a Number of Things..
It's most likely that the electrical Wire Could Have a Shortage, If it cuts off again Try gently Wiggling the Electrical Wire in a Number of Directions If it cuts on and off while your fidgeting with it, you've found your Problem! A quick fix would be to Adjust the wire In the position it would cut on the strongest, wrap the cord with Tape to Keep the wire in that Position, this will Prevent it from shorting again.
Either that or you simply put too much product in the Blender with an inadequate amount of liquid.
10/16/2022 6:43:20 PM •
Blenders
•
Answered
on Oct 16, 2022
•
9,330 views
The blender stopped spinning
blenders are:
power cord, switch, speed control, and motor.
A disassembly and VOM meter is required to determine which part is defective.
9/14/2019 10:13:18 PM •
Blenders
•
Answered
on Sep 14, 2019
•
219 views
Not finding what you are looking for?