20 Most Recent Jack Lalanne Health Master 100 8-Speed Blender - Page 5 Questions & Answers

https://youtu.be/dklwnGPwHVw

The shaft has probably become tight in the bearings and the assembly will need to be dismantled for cleaning and possibly lubrication - I am unfamiliar with the Ninja but the average blender is a fairly basic mechanism and not many fasteners have to be removed before the parts needing attention either fall off or can be removed. It is a fairly intuitive process for the handy person. You could perhaps start with the nut on the blade - there seems enough exposed thread to judge whether it is left or right hand thread and it shouldn't be particularly tight. Lots of cloth should be used when holding the blade...

The thermal fuse must be in intimate contact with the motor so when the motor temperature climbs dangerously high the fuse temperature doesn't lag far behind. I have seen the thermal fuse buried in the windings of a transformer so it isn't beyond the realms of possibility it could be inside the motor. The thermal fuse body is metal and live and so must be insulated and so is generally found in the supply wire inside some heat resistant sleeving strapped firmly to the motor...

try rotating the container part 1/4 of a turn to line up slots and press down . then if it does not blend turn another 1/4 turn to line up slots and press down pushing container into base motor unit . container and screw on blade lid is put in upside down and the plastic posts have to match the base unit to turn on the blender when you press down on container into base unit. I own and use a ninja blender !.

https://youtu.be/i5E-t09PFL4 watch this video

you checked at your nearest electronic shop,I think the motor available in that shop

https://youtu.be/i5E-t09PFL4 you watch this video & your problem is solved

so order one fixya doesnt sell products

fixya doesnt sell products

https://www.youtube.com/watch?v=LfY_-VA5m8A https://www.youtube.com/watch?v=AhXiPiaie1I

Hello, Rebecca - Please see my reply here: https://www.fixya.com/answer/answerpageslideview.aspx?thid=29753915&ctg=142&brd=3705 Best wishes.

Are you twisting in the right direction to release. I think you put on and twist to lock and twist the other way to unlock. https://www.youtube.com/watch?v=JPKGp3KFjcY https://www.youtube.com/watch?v=4XehR2C_6n0 manual https://www.manualslib.com/manual/1444596/Starfrit-024300.html?page=6#manual

typically, you can't repair it.

that happens to the best of them. Try heat soap, vinegar, and a tight grip to get it off.

blenders are: power cord, switch, speed control, and motor. A disassembly and VOM meter is required to determine which part is defective.

Use https://www.google.com and the words manual and whatever manufacturer and model it is to see manuals.

fixya is not ninja

Yes you can replace it for some kind of better device. I recommend you to check reviews about quiet blenders before purchasing some kitchen tools like that one.

https://www.bakedeco.com/images/manuals/USD-R-5AM.pdf

Is probably a binding problem with the motor shaft bearing or the circuit card is fried. If you've tried giving it a good cleaning and that didn't work it's a good bet the unit is junk. Suggest buy a new one.