Whirlpool Upright Freezer EV161NZRQ - Answered Questions & Fixed issues

Hi,

Check out these tips...they can help you figure out what is going wrong withyour refrigerator

Refrigeratornot Cooling or Fridge not Cooling

How to Defrost Refrigerator DefrostTimer Problem

WaterRunning in refrigerator from Freezer

Refrigeratoror Freezer not Cooling or Getting Cold
heatman101

As there is no adjustment possible to raise the door, the likely culprit is a bent lower door hinge, or a damaged cam riser. Also, I've had calls where the freezer was in the basement, and due to an eneven floor, usually for the purposes of water drainage, this can sometimes cause the freezer cabinet to get out of whack.

have your themostastic control replaced (stop wasting money)

You can get the door gasket on the link below.

http://www.appliancepartspros.com/part_details.aspx?part_id=3885131

Or you can see all the parts on this link below.

http://www.appliancepartspros.com/partsearch/model.aspx?model_id=5141528&diagram_id=938120#d938120


Good Luck and please rate 4 thumbs up for the free answer

putting unfrozen food in a freezer can raise the temp to cause it to go off allow 24 hours for it to stop if it dont replace the buzzer

Possibly has a restricted capillary tube. Possibly has a extremely dirty condenser coil. Possibly has a bad compressor which will run but has bad valves so it doesnt actually pump the refrigerant. If the condenser coil has a fan (unlikely) it may be dead and causing the unit to run much higher pressures than normal which could cause this. Only thing you really could do would be clean the condenser coil. Anything else would need to be repaired by an Refrigeration Mechanic.

usually the higher the number the colder it gets. Easiest way to tell on all models is the number closest to off is the warmest setting... Eric

There is a vacuum build up in the freezer compartment when you close the door. This can make the door difficult to open. You can overcome this by sticking a small lollipop stick to the bottom part of the door gasket. This will act as a vacuum breaker.

Question edited for clarity. This might be close enough? Contact details on Page 1 and 2. https://www.manualslib.com/manual/191418/Whirlpool-Upright-Freezer.html https://www.google.com/search?q=Whirlpool+SVF15NRHW01+manual ..

If your Whirlpool upright freezer is working fine but an intermittent alarm is sounding that is different from the high temperature alarm, it could indicate an issue with the door or the door switch. The alarm is designed to alert you if the door has been left open for an extended period or if the door switch is malfunctioning. Check the door seal to ensure it is tight and the door is closing properly. You can also try cleaning the door switch to see if that resolves the issue. If the problem persists, it may be necessary to contact a professional for further assistance.

??????? ?????? ?? ???? ??????? ???? ???? ?? ???? ?? ???? ???????? ????????? ???????? ???????? ? ???????? ??? ?? ???.

THIS question is your only question here on Fixya dot com! https://www.fixya.com/users/gregg-j-ajamian You just need a good search query to find stuff like this. Cut out all the extraneous words and use the bare bones. Videos in the link https://www.google.com/search?q=whirlpool+upright+freezer+EV250NXTQ03+remove+the+drain+grommet ..

There shouldn't be any 'jingly tone' at the end of every compressor cycle. You could be hearing something else making a sound after the compressor stops.

The larger one

The door switch or door module is defective. or the door is not fully closed

http://www.fixya.com/tags/freezer_green_light_flashing/browse/whirlpool

The defrost water from the melted frost (ice) collects in the bottom of the freezer. If there is no plugged up drain, then you must remove the water manually with a sponge and bucket after a defrost cycle.

If it’s in floor if freezer, you have a clogged defrost drain. If it’s on inside back freezer wall, it’s a defrost problem

The solenoids that operate the ice maker and the water dispenser in the door may be getting water internally. I would put a pressure regulator on the line of the pressure exceeds 30 PSI.

https://www.repairclinic.com/RepairHelp/Refrigerator-Repair-Help I’m happy to assist further over the phone at https://www.6ya.com/expert/david_dc2f9e0a44104720