20 Most Recent Whirlpool 10 cu. ft. Chest Freezer EH101FXR - Page 5 Questions & Answers

It uses the same compressor for both. One of two things, the opening that is allowing cold air in the freezer , is closed or the freon is leaking out and it will be soon before the fridge is not working.

Yes I could be. My advice, if this freezer is 10-12 years old or more, you may be getting ready to spend a lot of money starting now. If not, have somebody physically look at it. Hopefully, it is just the relay or capacitor.

You have a part going bad or a faulty read . Refer to your manual and see what it says under troubleshooting.

What is your question and model number? Is this a refrigerator that you need information about the infrared reciever? I have Whirlpool Electronic Infrared service information just not sure of your question or model number. Thanks, Sea BreezeModel Numbers can be found in these locations

I need you to feel the top of the compressor and tell me how hot it is. Also tell me if the condenser fan next to the compressor is running. If the top of the compressor is too hot to keep your hand on top the problem may be the=> 4356738 Start Relay also found here=> 4356738 Start Relay Here is a link to the repair parts list=> EVL201NXRQ00 Repair Parts List You can see the parts listed on page 5 and 6 of the above parts list. Hopefully this is the only problem causing your freezer to stop freezing as well. If the 4356738 Start Relay is defective it will cause the problems by not allowing the compressor to run or start very well also cause the top of the compressor to overheat. You may also need to change the=> 8210224 Capacitor also found here=> 8210224 Capacitor And the=> 2-34286-021 Overload also found here=> 2-34286-021 Overload Feel the top of the compressor first and let me know the results and we will go from there, Thanks Sea Breeze

Probably the dual water valve (that opens when the ice maker needs water ) is leaking and the filling tube gets clogh with ice , or the valve doesn't work ,in both cases it has to be replace.

This is normal. There is an electric, (mullion), heater behind that surface that keeps condensation from forming. It also keeps the freezer door gasket from freezing to the surface and ripping when the door is opened.

Sounds short of gas. Need a technician

If it spins for 10 mins it's not the capacitor, it's the fan

Will a normal defrost timer not do?

the ice maker is not cutting off clean inlet valve shut off