Top 20
La Crosse XG-55 Wrist Watch - Page 4 Questions & Answers
Change battery on aqualite 30M watch
Hi,
please view the back of the watch and look for screw or plastic latch that you can use to open the back and access your watches battery. You can search amazon or bestbuy for a replacement battery and then order it. But if you find it hard to open the back of the watch, you can visit a local watch store to help you with that and they might have a replacement battery for you as well.
Thank you.
12/10/2022 11:56:12 PM •
Watches
•
119 views • 1 helpful votes
Need help with removal of 97P144 links
Removing links from a 97P144 watch band can be a bit tricky, but with the right tools, it can be done. Here is a step-by-step guide on how to remove links from your 97P144 watch band:
- Gather the tools: You will need a small screwdriver, a pair of pliers, and a link removal tool (specifically designed for removing links from watch bands).
- Locate the link pins: Look at the back of the band and locate the link pins that hold the links together. These will be small, thin pins that run through the links and hold them in place.
- Use the screwdriver: Use the small screwdriver to push down on the head of the link pin, and then use the pliers to gently pull the pin out of the link. Be sure to keep a firm grip on the pin as you pull it out, as it can be tricky to remove.
- Repeat the process: Repeat this process for each of the link pins that you want to remove.
- Use the link removal tool: Use the link removal tool to push the link out of the band.
- Reassemble the band: Once you have removed the desired number of links, reassemble the band by pushing the link pins back into place and securing them with the screwdriver.
Be sure to take your time and work carefully, as you don't want to damage the band or the watch itself during the process.
11/7/2022 4:48:23 AM •
Watches
•
190 views • 0 helpful votes
How do i shutdown hourly beep in mingrui spots watch
To turn off the hourly beep on a Mingrui sports watch, you can try the following steps:
- Press and hold the "Mode" button until the watch enters the settings menu.
- Use the "Adjust" button to navigate to the "Beep" or "Alarm" option.
- Press the "Adjust" button to turn off the hourly beep.
- Press the "Mode" button to exit the settings menu.
Please note that these steps may vary depending on the specific model of Mingrui sports watch you have. It's recommended to refer to the user manual for your specific watch for detailed instructions.
9/20/2022 6:33:57 AM •
Watches
•
626 views • 0 helpful votes
Ingiglo does not light up what to do? can't change date either--what to do?
If your Iniglo watch is not lighting up and you are unable to change the date, there may be a problem with the battery or the watch's internal components. Here are some steps you can try to troubleshoot the issue:
- Check the battery: Make sure the battery is installed correctly and has a sufficient charge. If the battery is dead or low, try replacing it with a new one.
- Clean the contacts: Use a soft cloth to clean the battery contacts and the contact points inside the watch to ensure a good connection.
- Check the setting: Make sure the watch's backlight setting is turned on and the brightness is adjusted to a level that allows you to see the display in the current lighting conditions.
- Reset the watch: Try resetting the watch by pressing and holding the "reset" button (if your watch have) for a few seconds.
- Check for water damage: If the watch has been exposed to water, it could cause damage to the electronic components. If water has entered the watch, it is best to take it to a professional watch repair center for service.
- Check if the watch have a warranty: If the watch is still under warranty, you should contact the manufacturer for service or repair.
12/4/2022 4:38:50 PM •
Watches
•
64 views • 0 helpful votes
Accutime minecraft smartwatch wont boot or take charge
The battery ran down too far. Lithium battery controllers typically lock out if the battery is discharged below 2.6 Volts per cell because trying to recharge at standard current could cause a fire. Even if you can bring the battery back above the lockout voltage using a very low charge current, it may be damaged and will need more frequent recharging.
In other words, your best bet is to replace the battery.
7/31/2022 4:30:26 AM •
Watches
•
617 views • 0 helpful votes
Not finding what you are looking for?